Resolution RE116-U User Manual
USE THIS MANUAL IF USING THE SPECIAL TRANSMITTER TO SEND
1. Panel siren output
2. Transmitter tells
3. Wireless siren
4. Wireless siren sends
Special
More than one
HIGH VOLUME STATUS BEE
PS
ENROLL
ENROLL
1
2
1 2
1
2
1 2
HIGH VOLUME STATUS BEEPS
SIGNAL TO SIREN
RE116-U Wireless Siren, Universal
using RE150 Special Transmitter
Features
• Remote Wireless Siren
• Works with any panel with siren terminals
• Special transmitter at panel sends siren signals
• Siren cadence synchronized to panel
• Automatically follows panel beep volume
• Wall-powered, with backup power on CR123A battery
• Can use multiple Sirens on one panel
• Cover tamper
• Unparalleled wireless range
• Low Battery indication
• 3x4x1.25 inches
• Siren can also respond to a GE Key Fob (instead of a Panel)
How it works:
Key Instructions
TYPICAL HARDWIRE CONNECTIONS
Refer to Siren Hardware Connections for specific panel connections and settings.
Connect Special Transmitter to Control Panel Siren:
•
Remove Special Transmitter battery during install.
•
MOUNT SPECIAL TRANSMITTER OUTSIDE
ANY METAL CANS!
RE116-U Universal Wireless Siren Instructions Page 1 of 4 29-Oct-14
Transmitter
terminals signal alarm or
status beeps
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
wireless siren to make
noise, following siren
terminals pattern
supervisories, low battery and
tamper statuses
(GE systems only)
SIREN +
SIREN -
makes same noise
pattern as panel
4.7K
siren can be
used
USE THIS MANUAL IF USING THE SPECIAL TRANSMITTER TO SEND
SIGNAL TO SIREN
ENROLLMENT
Open the Siren battery door, giving access to the programming switches.
Power the Special Transmitter with its battery.
Power the Siren with its battery.
Enrolling Special Transmitter into Siren – to send panel siren signals to Siren
1. Put Siren Function in ENROLL Mode.
low volume status beeps
2. Press and release the Special Transmitter tamper switch.
The Siren will beep 4 times, indicating enrollment.
3. IMPORTANT: Put cover on Special Transmitter.
4. Put Siren Function Switches in RUN Mode.
Select low volume or HIGH VOLUME status beeps
low volume status beeps
DO THESE STEPS ONLY IF PANEL IS A GE SYSTEM.
RE150 Special Transmitter
#2
#1
#2
#1
Battery
Enrolling Siren in Panel – to monitor both Special Transmitter and Siren
(Siren only talks GE wireless):
• If you want to have Siren monitor the Special Transmitter
In Step 2 above, instead of using the Special Transmitter’s tamper switch to
enroll, pull and replace Special Transmitter battery. Siren will beep 8 times.
IMPORTANT: You must NOT enroll Special Transmitter in panel.
Panel will go CRAZY with alarms.
5.After step 4 above, enroll Siren into GE panel:
With Panel in enroll mode…Cycle tamper switch on Siren. Enroll in Group 10.
Put cover on Siren.
Plug Siren in wall.
System is ready to operate.
MULTIPLE SIRENS:
You can enroll multiple sirens in one system. Just enroll the same single original
Special Transmitter in the 2nd Siren. Simply repeat Steps 1-4 with the 2nd Siren.
TO DRIVE SIREN FROM KEY FOB (instead of driving Siren from Panel)
Repeat Steps 1-4, but use Key Fob Lock + Unlock, instead of Special Transmitter.
TO CHECK SPECIAL TRANSMITTER SIREN LINK:
Tamper, or install the battery in the Special Transmitter Siren will beep twice.
RE116-U Universal Wireless Siren Instructions Page 2 of 4 29-Oct-14
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
RUN
RUN
USE THIS MANUAL IF USING THE SPECIAL TRANSMITTER TO SEND
Tamper Switch
Function
Red LED
Green LED
Battery isolator tab.
Special Transmitter
- Terminal #1
Wireless Siren
SIGNAL TO SIREN
Operation
• Alarm
• GE panels only:
• Key Fob Response [if you instead enroll a GE-Compatible Key Fob into Siren]
+ Terminal #2
Battery “+”
RE116-U Universal Wireless Siren Instructions Page 3 of 4 29-Oct-14
Siren follows panel alarm pattern.
Some panels (Lynx, 2GIG) cannot drive siren without AC power.
• Supervision
Siren sends supervisory signals to panel IF:
Siren has AC power.
AND, if Special Transmitter is enrolled in Siren…
Siren has heard signal from Special Transmitter in previous 60
minutes.
• Tamper
When cover is opened on Siren, or on Special Transmitter if enrolled.
Lock Low-level beeps for 5 seconds
Lock & Unlock High-level beeps for 5 seconds
Star Low-level beeps for 4 minutes
Star & Light High-level beeps for 4 minutes
Unlock Silence
Switches
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
• Enroll Mode:
Short ON flashes when
waiting to enroll… Short
OFF after Special
Transmitter is enrolled
Battery “+”
• ON if AC Present.
• Flickers when
hearing wireless signals
from its enrolled
Transmitter.
Remove.
USE THIS MANUAL IF USING THE SPECIAL TRANSMITTER TO SEND
SIGNAL TO SIREN
Siren Specifications
Device Behavior: Siren Supervision in GE panels acts like a
Supervisory Time 64-68 minutes
Alarm Patterns: Follows panel Siren ON/OFF Directly
Alarm Sound Intensity 85dB, minimum, at 1m
Receiver: Dual antenna diversity
Transmitter> Dual antenna Dirersity
Electrical Connection: US 2-prong Electrical outlet blades
Mounting hardware: Secure with outlet plate mounting screw
Terminal wire capacity: 16 Gauge
Backup Battery Life: 48 hours cumulative, non-rechargeable
Back-up Battery: CR123A 1550 mAH
Temperature Range: 0F to 120F
Housing dimensions: 3x4x1.25 inches
Specifications subject to change without notice.
Notices
“GE”, “Honeywell”, and “DSC” are trademarks owned by General Electric Company, Honeywell International Inc., and Tyco
Safety Products Canada LTD, respectively.
Resolution Products, Inc. products will function with one of either GE, DSC or Honeywell systems. However, no Re solution
product is produced by, endorsed by, nor is officially associated with GE, Honeywell or DSC. Resolutio n recommends verifying
proper enrollment and operation, per control panel installation instructions, at installation.
Warranty
Resolution Products, Inc. will replace products that are defective in their first five (5) years.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference that may be received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could void the user's authority to
operate this equipment.
FCC ID: U5X-RE116 (Siren)
FCC ID: U5X-RE150 (Special Transmitter)
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1)This device may not cause interference, and
(2)This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A-RE116 (Siren)
IC: 8310A-RE150 (Special Transmitter)
RE116-U Universal Wireless Siren Instructions Page 4 of 4 29-Oct-14
24-Hour Tech Support Line: (715)808-0164
Door/Window Battery & Tamper
Shortest ON pulse: 250 ms
Shortest OFF Pulse: 250 ms
www.ResolutionProducts.com
Loading...