Resolution CryptiX, HeliPad RE656 Series Setup Manual

RE656 Series CryptiX™ HeliPad

™

HeliPad is an arming station that provides real-time

system status. It is battery powered and requires no
installation tools. A direct wireless link to Helix allows
for local control of the Helix control panel, regardless
of network connectivity.

Features

• E ink® display provides real-time status

• Non-mechanical capacitive touch interface

• Runs on user-replaceable AAA batteries

• 5 year warranty

Screw

Location

VHB Tape

Mounting

Plate

VHB Tape

Operate using the capacitive buttons, which click when

activated. Note, Arming buttons won’t click until they
are held for at least one second.

• Disarm by entering a valid 4-10 digit user
code on the number pad.

• Arm Away by pressing ARM AWAY
until HeliPad clicks.

• Arm Stay by pressing ARM STAY
until HeliPad clicks.

• Trigger a panic alarm by pressing ARM
STAY

& ARM AWAY together
until the display indicates a panic alarm.
HeliPad will click rapidly while buttons are
held.

Enroll by rst removing the battery pull tab. Then, press

MENU to enter the enrollment menu. Next, place
Helix control panel into wireless enrollment mode.
Finally, press SELECT to enroll HeliPad.

• Once enrolled, arm and disarm Helix to
verify HeliPad is within range of Helix and
properly enrolled.

Install on vertical surface using the 3M VHB

®

tape on the

back of the mounting plate.

• See Pro Tips for recommendations about
using VHB tape.

• A #4 or #6 screw may also be used, but
only in addition to the VHB tape. The tape
prevents HeliPad from rotating on the wall.

Use the Helix installation guide to verify proper system setup.

I

N

S

T

A

L

L

G

U

I

D

E

I

Home

Screen

Panel AC Status

AC OK

AC Removed

System Status

Arming Level

Disarmed

Armed Stay

Armed Night

Armed Away

Miscellaneous

Normal Display

Low Battery Warning

Helipad is receiving

new rmware from

control panel

Helipad rmware has

successfully updated

OK

Trouble

View system status using the icons

displayed on the home screen.

• Arming Level shows the
current arming level of the
system.

• Panel AC Status indicates
whether Helix has AC Power.

• System Status indicates
whether there are any
trouble conditions. Tap

MENU

to view trouble

conditions.

• Miscellaneous indicators are
sometimes displayed instead
of the dealer logo (e.g. low
battery, update in progress).

Silent Arming

On

Off

Entry Delay

On

Off

Night Arming

On

Off

Chime Mode

On

Off

Change arming settings and chime mode using the

quick settings tab. The quick settings tab is opened by
pressing SELECT .

Quick Settings Navigation

• Use

UP/DOWN to select a setting.

• Use SELECT

to enable/disable a setting.

• Use MENU

to close the quick settings.

Quick Settings Tips

• When night arming is enabled pressing ARM

STAY

will arm to NIGHT rather than STAY.

• The quick settings tab will automatically close
after roughly 5 seconds of inactivity.

Alarm status indications use the entire HeliPad screen. See examples below.