Resolution CryptiX NanoMax RE622 Series User Manual

RE622 Series CryptiX™ NanoMax™ Door Window Sensor

I

NanoMax is the smallest full-featured security transmitter

in the industry. It is typically used to sense opening and
closings of doors and windows, but can secure just about
anything using its Strip & Stick™ external contact holes. It will
alarm when the magnet is pulled away from the NanoMax or
when the external contact is opened.

Features

• Quick peel and press mounting

• Small prole for a near invisible look

• Most exible magnet positioning in the industry

• Strip & Stick external contact holes

• 5 year warranty

Enroll by placing the panel into wireless enrollment mode

and then sending an enrollment signal from NanoMax.
Alternatively, NanoMax can be enrolled by scanning its bar
code using the HeliLink app or by entering its 8-character
serial number on the interactive service provider’s web
portal.

Options for sending an Enrollment Signal

• Remove the battery tab, which can be done
without removing the cover, OR

• Touch the magnet to the sensor 5 times within
5 seconds, OR

• Remove the cover to trip tamper

A

T

S

L

L

N

I

G

E

U

D

I

Install by removing the adhesive paper and adhering the

NanoMax and magnet on a door or window. Make sure to
align the alignment marks on the NanoMax and magnet
when mounting. Alternatively, NanoMax can be used with an
external contact instead of the reed switch.

External Contact (not evaluated by ETL)

• If you are using the external contact then you
cannot use the reed switch.

• Use a normally-closed contact because
NanoMax will transmit an alarm when it sees
the external contact open.

• Do not use end-of-line resistors.

• Connect the contact to NanoMax by inserting
the contact’s wires into the two Strip & Stick
holes on the back of NanoMax.

• Additional wiring information can be found by
searching www.ResolutionProducts.com for
“external contact wiring”.

Use the Helix installation guide to verify proper system setup.

Pro Tips

3M VHB Tape works great if the surface is properly prepared and rm pressure is applied

for over 10 seconds.

Surface Preparation

• Clean the surface

• Ensure the mounting surface temperature is above 50 °F

Wireless performance is optimized when mounted near the top of the door in a vertical

orientation.

OK BESTWRONG

Accessories

MetalMax™ NanoMax Mounts (RE033-16) can

be used for better performance on metal and
narrow mounting situations.

• Improves wireless performance by
moving the internal antenna away from
metal surfaces.

• Provides an alternate mounting
orientation for narrow installs.

• Increases magnet gap distance on
metal surfaces.