Date: Mar. 30, 2021
TOYOSU FORESIA, 3-2-24, Toyosu, Koto-ku, Tokyo 135-0061, Japan
Renesas Electronics Corporation
Resolver-to-digital converter ICs
Correction of errors and addition of a control
register
RAA3064002GFP
RAA3064003GFP
Resolver-to-Digital Converters
User’s Manual: Hardware Rev.1.10
(r03uz0002ej0110)
TN-RDC-A0002A/E
This document is to notify you of the correction of errors and addition of a control register in the user’s manual of the
applicable products. The corrections were made in section 3.2.7, ALARM# Output Setting Register (ALMOUT) and section
3.2.12, Correction Circuit Gain Selection Register (CCGSL). Additions were made to table 3.1, List of Registers, and to section
3, Control Registers, as section 3.2.14, Over-Temperature Detection Circuit Control Register (FOPER).
(c) 2021. Renesas Electronics Corporation. All rights reserved. Page 1 of 6
RENESAS TECHNICAL UPDATE TN-RDC-A0002A/E Date: Mar, 30, 2021
Power-saving control register 1
Power-saving control register 2
Power-saving control register 3
Differential amplifier input range monitoring register
ALARM# output setting register
Monitor output selection register
Monitor output mode selection register
Differential amplification circuit gain selection register
Phase adjustment circuit gain adjustment value
selection register
Correction circuit gain selection register
Shunt current amplification circuit control register
Differential amplifier input level detection resetting
register
Power-saving control register 1
Power-saving control register 2
Power-saving control register 3
Differential amplifier input range monitoring register
ALARM# output setting register
Monitor output selection register
Monitor output mode selection register
Differential amplification circuit gain selection register
Phase adjustment circuit gain adjustment value
selection register
Correction circuit gain selection register
Shunt current amplification circuit control register
Over-temperature detection circuit control register
Differential amplifier input level detection resetting
register
Page 18 of 52
A control register was added to table 3.1, List of Registers, as follows.
[Before Addition]
3.1 List of Registers
Table 3.1 List of Registers
[After Addition]
Table 3.1 List of Registers
Page 2 of 6