Remote Technologies RTI0700 User Manual

M2

Operation Guide

v1.0

M2

IR-PRO

Universal System Controller

Professional Infrared Code Capture System

i

Reorient or relocate the receiving antenna.

FEDERAL COMMUNICATIONS COMMISSION NOTICE

This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation.

If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

•

• Increase the separation between the equipment and the

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference and (2) this device must accept any
interference received, including interference that may cause
undesired operation.

FCC ID: MMURTI0700

CAN: 3166-RTI0700

M2 Universal System Controller

ii

BATTERY DISPOSAL

This product is shipped with non-rechargeable alkaline batteries.
These batteries are generally considered not to be environmentally
hazardous. In most cases they can be disposed of in normal
household trash, but you should always verify and follow your
local regulations.

Do not burn or incinerate used batteries, as it may cause internal
materials to explode.

It is important not to dispose of large amounts of alkaline batteries
in a group. Used batteries are often not completely "dead."
Grouping used batteries together can bring these "live" batteries
into contact with one another, creating safety risks..

SAFETY SUGGESTIONS

Read Instructions. Read all safety and operating instructions
before operating the unit.

Heat. Keep the unit away from heat sources such as radiators,
heat registers, stoves, etc., including amplifiers that produce heat.

Batteries. When replacing batteries, use only new ones. Do not
mix new and used batteries together. Rechargeable batteries are
not recommended for this product.

Cleaning. The unit should be cleaned only as recommended in the
operating guide.

Servicing. Do not attempt any service beyond that described in
the operating guide. Refer all other service needs to qualified
service personnel.

Damage Requiring Service. The unit should be serviced by
qualified service personnel when the unit does not appear to
operate normally or exhibits a marked change in performance.

iii

LIMITED WARRANTY

Remote Technologies Incorporated warrants its products for a
period of one (1) year (does not apply to included batteries) from
the date of purchase from Remote Technologies Incorporated or
an authorized Remote Technologies Incorporated distributor.

This warranty may be enforced by the original purchaser and
subsequent owners during the warranty period, so long as the
original dated sales receipt or other proof of warranty coverage is
presented when warranty service is required.

Except as specified below, this warranty covers all defects in
material and workmanship in this product. The following are not
covered by the warranty:

Damage resulting from:

1. Accident, misuse, abuse, or neglect.

2. Failure to follow instructions contained in this Guide.

3. Repair or attempted repair by anyone other than Remote

Technologies Incorporated.

4. Causes other than product defects, including lack of skill,

competence or experience of user.

5. Shipment of this product (claims must be made to carrier).

6. Being altered or which the serial number has been defaced,

modified or removed.

Remote Technologies Incorporated is not liable for any damages
caused by its products or for its failure of its products to perform,
including any lost profits, lost savings, incidental damages, or
consequential damages.

Remote Technologies Incorporated is not liable for damages based
upon inconvenience, loss of use of the product, loss of time,
interrupted operation, commercial loss, any claim made by a third
party or made by you for a third party.

Remote Technologies Incorporated’s liability for any defective
product is limited to repair or replacement of the product, at our
option.

M2 Universal System Controller

iv

If your M2 needs service, please contact Remote Technologies
Incorporated by telephone, fax or e-mail for return information.

Please do not return products to RTI without return
authorization.

DISCLAIMER

All rights are reserved. No part of this document may be
photocopied, reproduced, or translated without the prior written
notice of Remote Technologies Incorporated.

The information contained in this document is subject to change
without notice. Remote Technologies Incorporated shall not be
liable for errors or omissions contained herein or for consequential
damages in connection with the furnishing, performance, or use of
this guide.

Microsoft and Windows are registered trademarks of Microsoft
Corporation. Other brands and their products are trademarks or
registered trademarks of their respective holders.

M2, It’s Under Control, TheaterTouch, and the RTI logo are
trademarks of Remote Technologies Incorporated.

Contents

Federal Communications Commission Notice ---------------------- i
Battery Disposal ----------------------------------------------------------- ii
Safety Suggestions -------------------------------------------------------- ii
Limited Warranty -------------------------------------------------------- iii
Disclaimer-------------------------------------------------------------------iv

Contents------------------------------------------------------------------------ v
Chapter 1. Welcome----------------------------------------------------------1

Compatibility Note---------------------------------------------------------1
Unpacking and Inspection -----------------------------------------------2
Product Contents -----------------------------------------------------------2
Software Requirements ---------------------------------------------------2

Chapter 2. Introduction -----------------------------------------------------3

Features-----------------------------------------------------------------------3
Important Notes ------------------------------------------------------------4
Cleaning ----------------------------------------------------------------------4
Getting Started --------------------------------------------------------------5
Remote Reference ----------------------------------------------------------6

Chapter 3. Operation---------------------------------------------------------9

The LCD Display -----------------------------------------------------------9
The Control Panel Page ------------------------------------------------- 10

Adjust Contrast -------------------------------------------------------- 11
Beeper -------------------------------------------------------------------- 11
Time Out ---------------------------------------------------------------- 11
Tilt Switch--------------------------------------------------------------- 12

Change Passcode ------------------------------------------------------ 12

v

M2 Universal System Controller

vi

Clear All ----------------------------------------------------------------- 14
Low Battery Indicator --------------------------------------------------- 15
Programming The M2--------------------------------------------------- 15

Chapter 4. Troubleshooting---------------------------------------------- 17

Display is Dim, Blank or Unreadable-------------------------------- 17
USB Communication Problems --------------------------------------- 17
IR Code Problems -------------------------------------------------------- 17

Chapter 5. Service and Support----------------------------------------- 19

Updates and New Products-------------------------------------------- 19
Contacting Remote Technologies Incorporated ------------------- 19
RTI Technical Support -------------------------------------------------- 19

Specifications---------------------------------------------------------------- 21

Chapter 1. Welcome

Thank you for purchasing the M2 universal system controller. The
M2 combines the power and flexibility of a graphic LCD display

with an ergonomic design that permits effortless one-handed
operation. This design overcomes the need for a compromise
between form and function. Sleek and perfectly balanced, the M2
is infinitely flexible and expandable.

The M2 takes complete control of your home electronics, replacing
all other remotes. It features an intuitive, easy to read LCD that
can display custom text, graphics, symbols, and icons. In addition
to the backlit display, 33 “Hard” keypad buttons allow easy access
to frequently used functions.

Programming is easy and convenient thanks to the Windows®
based TheaterTouch Designer™ software. Because RTI’s remote
control products are sold only through professional
installers/programmers, and never directly to consumers, it is our
philosophy to not incorporate programming capability directly
into our products. Instead, we are committed to providing our
dealers with the hardware and software tools that allow them to
create re-usable programming databases and templates in the
most efficient and reliable way possible.

The M2 is capable of both infrared and radio frequency output.
Optional RF receivers are available for transmission through walls
and cabinets. The RF receivers connect to an RTI control system
for the ultimate in control reliability and flexibility. RTI control
systems can provide many advanced features such as IR routing,
local macro execution, power sensing, and RS-232 control.

COMPATIBILITY NOTE

The M2 and TheaterTouch Designer software are compatible with
infrared (IR) commands with carrier frequencies between 15KHZ
and 460KHZ, as well as those commands that do not use a carrier.
This covers virtually all of the remotes that exist to date.

1

M2 Universal System Controller

2

UNPACKING AND INSPECTION

After unpacking your new M2 universal system controller, save
all of the packing materials in case you ever have to ship the unit.

Thoroughly inspect the M2 and packing materials for signs of
damage. Report any damage to the carrier immediately. Report
any equipment malfunctions to Remote Technologies
Incorporated or an authorized Remote Technologies Incorporated
distributor.

PRODUCT CONTENTS

Contents within the box include the following items:

§ One (1) M2 universal system controller

§ Four (4) AAA alkaline batteries.

§ One (1) Operation guide.

SOFTWARE REQUIREMENTS

The recommended minimum system requirements needed to run
the TheaterTouch Designer software are as follows:

§ Windows 98SE

®

, Windows ME®, Windows 2000®, Windows

XP® or later version.

§ A free USB port.

§ At least 64 Megabytes of RAM.

§ At least 100 Megabytes of free disk storage.

§ Screen resolution of 800x600 with 16-bit color.

§ A mouse is required.

§ Optional printer for printing reports.