Page 1
WET2
straight!
S8002
090221_REM_IFU_S8002_22L.indd 1 17:21:19|30.04.09 Guido Krölls
120 - 240V
MULTI VOLTAGE
5
Page 2
WET2
straight!
&
'
.
%
$
090221_REM_IFU_S8002_22L.indd 2 17:21:21|30.04.09 Guido Krölls
+ * ) (
-
(
,
Page 3
ENGLISH
Thank you for buying your new Remington® product. Before use, please read the
instructions carefully, and keep them in a safe place for future reference.
PRODUCT FEATURES
GBDNLFEIDKSFINPSKCZPL
A. Wide plates for lo nger ha ir
B. Ceramic plates infused with anti-frizz enhancing conditioners specially engineered to
last t he life o f the product .
C. Digital LCD displ ay 150 – 230°C
D. Special vent s to channel e xcess water away a nd allow w ater to evaporate qu ickl y
E. On/Off switch
F. Wet/ Dry button
G. Switc h lock f unction – Set t he desired temper ature by pressing +/- b uttons and lock
the switch se ttin gs by pre ssing t he ‘-‘ but ton fo r 2 seconds. A ‘padlock ’ symb ol will
appe ar on your LC D screen. Thi s will pr event ac ciden tall y changing th e temp erature
sett ings wh ile usi ng the s traighten er. To unlock the switc h sett ings , press a nd hold t he
‘-‘ switch again.
H. Heat B oost f unction – aut omati cally sets to t he highest te mper ature .
I. Autom atic safety shut of f – Unit w ill aut omaticall y switch itse lf of f if lef t on after 60
minutes.
J. Heat proof pouch
K. Swivel cord
5 year guarantee
(110mm longer length plates)
1
HR/
HUN
RUTRROGRSLAE
SRB
HE GB
090221_REM_IFU_S8002_22L.indd 1 17:21:21|30.04.09 Guido Krölls
Page 4
ENGLISH
ENGLISH
INSTRUCTIONS FOR USE
:(7'5<6(77,1*
This straightener can be used on wet or dry hair.
:(702'(8VHRQWRZHOGULHGKDLU
When you turn the straightener on, it will automatically be set to wet mode and default to
200°C – The LCD will be blue
Adjust the temperature using the +/- switches to suit your hair.
For best results on wet hair – use straightener on 230°C and be sure to heat up the unit
for 10 minutes so that is reaches its optimum temperature.
NOTE: When straightening wet hair you will hear a hissing sound and the unit will steam.
This a good thing – it’s the sound of excess water in your hair evaporating and it is not
harmful to the condition of your hair.
'5<02'(8VHRQGU\KDLU
When you want to use straightener on dry hair, press the wet/dry button and the LCD will
turn green, WKH
WKHWHPSHUDWXUH\RXDUHFXUUHQWO\XVLQJ
Adjust the temperature using the +/- switches to suit your hair.
Recommendation –
150°C-200°C – best to use on fine, damaged or fragile hair
200°C-230°C – best to use on thick, wavy or difficult to manage hair
*(1(5$/,16758&7,216
Wash and condition your hair as normal.
Towel-dry hair thoroughly, removing all excess water.
Comb carefully through your hair, making sure it is free from snags or tangles.
Plug in your wet2straight™ and switch it on. The LCD display will light up.
Adjust the temperature buttons to suit your preference. When the desired temperature is
reached, the LCD will stop flashing and the unit will beep.
Divide hair into manageable sections and prepare to straighten the lowest sections of your
hair first.
Starting at the base of the neck, place a section of hair between the plates, ensuring that
the vents top of the straightener are directed away from the face/scalp. Remember: the
smaller the sections, better the results.
Close the plates and immediately glide the straightener down the section of hair - gently
moving from roots to tip.
Continue to run the section of hair between the plates until the preferred straightening
and drying is achieved. For thicker hair, you may need to go over sections more than once.
When styling is complete hold the on/off button too turn the unit off, unplug and allow to
cool before storing.
BETTER RESULTS
Results with wet2straight™ are better than with a normal straightener because the cuticle
is not being roughened up by the hairdryer. Instead, it lies flat from wet to dry, leaving hair
shiny, smooth and protected.
FORXGLFRQZLOOGLVDSSHDUDQGWKHWHPSHUDWXUHZLOOGURS&ORZHUWKDQ
DQG\RXZLOOVHHDFORXGLFRQDSSHDURQWKHGLVSOD\
2
090221_REM_IFU_S8002_22L.indd 2 17:21:22|30.04.09 Guido Krölls
Page 5
ENGLISH
DO’S
Do ensure vent holes are directed away from face, head or hair.
Do make sure hands are dry before using wet2straight™ and don’t hold them over the
vent holes.
Do use wet2straight™ on dry hair if required.
Do use wet2straight™ on wet hair - just ensure hair is towel-dried before use.
DON’TS
Don’t allow dripping wet hair to come in contact with this straightener.
Don’t use a normal ‘dry’ straightener on wet hair.
Don’t be alarmed when you hear a hissing sound and see steam - it’s the sound of the
excess water. When wet2straight’s plates come in contact with towel-dried hair, this is
perfectly normal.
IMPORTANT INSTRUCTIONS
Due to the extreme heat capabilities of this styler, extra care should be taken when using.
Before use, make sure hair is towel-dry and tangle-free. This straightener can also be used
on dry hair.
The unit has adjustable +/- temperature buttons. Choose lower temperature settings for
fragile, bleached or dry/damaged hair. Choose higher temperature settings for thick or
difficult to straighten hair.
It is very important that the holes in the plates are held away from the face and hair, as the
water from the hair will escape through the holes as steam, which is very hot.
For shorter hair, place a plastic comb between scalp and styler to avoid touching scalp.
Do not leave switched on for more than 30 minutes.
Before use, make sure hair is clean, dry and tangle-free.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface.
Only hold unit at the end of the handle. Ensure the heat protection pad is used in all cases.
Do not style too close to scalp, face, ears, neck and skin.
Please note regular use of styling products may deteriorate the coating. Wipe clean
regularly to maintain performance.
Do not use an abrasive cleaning fluid to clean the plates, as damage will occur. Use a soft
damp cloth on the unit while unplugged.
Do not scratch the surface of the plates as this will deteriorate the effectiveness of the
coating.
For extra p rotec tion and best r esult s, sec tion h air pri or to straigh tenin g and spr ay wit h
heat protection spray. Always str aight en the lower laye rs firs t.
GBDNLFEIDKSFINPSKCZPL
HUN
RUTRROGRSLAE
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a damp
cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
090221_REM_IFU_S8002_22L.indd 3 17:21:22|30.04.09 Guido Krölls
CLEANING AND MAINTENANCE
3
HR/
SRB
HE GB
Loading...