Remington CB-75i User Manual

SPECIAL FEATURE

This brush features solid-state electronic
circuitry with a heat sensor that detects
temperature loss and quickly boosts the
power to bring the heat level back to
optimum styling temperature. This allows
for styling in half the time it takes with an
ordinary brush.

This appliance is designed to operate on
120/240 volts, 50/60 Hz. It is not intend­ed for commercial use. Hair should be
clean, dry or nearly dry, and free of tan­gles before using.

HOW TO USE

For complete styling, hair should be clean,
dry and free from dirt, hair spray, creams,
etc. (This curling brush can also be used
for quick touch-ups any time.)

1. Rest the curling brush on a smooth,
flat surface, and plug it in.

2. Press ON/OFF switch, and the power
indicator light will flash.

3. Select a temperature according to the
type and texture of hair to be styled.

4. With heat control dial set at desired
position, allow unit to pre-heat. The
power indicator light will begin to
flash to signal that appliance is heat­ing up. When appliance is fullly heat­ed the indicator light will stop flash-

How to Use (con’t)

ing. Note: For optimum styling per-
formance, let the brush continue to
heat for about 2 minutes before using.

THIS CURLING BRUSH CAN ALSO BE USED
AS A 3/4” CURLING IRON BY REMOVING
THE CURLING BRUSH ATTACHMENT

1. Unplug the unit and let it cool completely.

2.

Remove brush attachment by holding the unit
firmly by the handle and sliding off Curling Brush.

3. Plug in and let heat.

FOLLOW THE SAME INSTRUCTIONS IN THIS
BOOK WHEN USING UNIT AS A CURLING IRON.

HOW TO GET PROFESSIONAL RESULTS
WITH YOUR CURLING BRUSH

This unique curling brush has been designed with
multiple temperatures, providing very high heat in
the Hl (25-30) settings for curling very coarse,
thick, hard-to-curl hair, and very low heat in the
LO (1-6) settings for curling extra fine, damaged
or dry hair. It also provides a full range of heat
settings between LO and HI, for all normal
textures and thicknesses of hair.

TEST A SMALL SECTION OF HAIR BEFORE
USING; THEN ADJUST TEMPERATURE
DEPENDING ON TYPE OF HAIR.

HEAT SETTINGS

WARNING

This multiple temperature curling brush has been
specially designed to curl very coarse, thick, hard­to-curl hair. Due to this special application, the
barrel of this curling brush will be hotter on the HI
(25-30) settings than regular dual-heat curling
brushes. Due to the extreme capabilities of

this brush, the barrel will be very hot in the
HI (25-30) settings, so extra care should be
taken when using.

• Keep unit away from contact with all skin
areas. Do not touch barrel with fingertips.

• For shorter hair, place a thin plastic comb
between scalp and curling brush to avoid
touching scalp.

• Place fingers of free hand on safety tip when
more control is needed
for curling.

• Test small section of hair to
determine correct heat setting for
the type of hair being styled.

HI (25-30)

These settings are very hot. Use only if hair
is very coarse and highly resistant, but in
good condition.

MED/HI (19-24)

Use heat settings in this range for dense,
hard-to-curl hair in good condition.

MEDIUM (13-18)

Use heat settings in this range for thick, wavy hair
in good condition.

LO/MED (7-12)

Use heat settings in this range for easy-to-curl,
normal hair.

LO (1-6)

Use LO heat setting for very fine, fragile, damaged
light-colored hair.

STYLING

1. Taking one section at a time, use the curling
brush to roll hair in the direction of the curl
desired, and hold a few seconds.

2. When using as a curling iron, take one sec­tion at a time, lift clamp and place end of hair
under the clamp so that it extends a little past
the clamp. Release clamp so that it closes
over the end of the hair. Roll hair in desired
direction and hold for a few seconds.

3. The cool tip can be a great help in winding.
Use one hand on the handle and the fingers
of the other on the cool tip.

NOTE: To avoid tangling, do not wind
hair around the curling brush more
than two times.

3. When hair feels warm, the curl is set.

4. Carefully remove curling brush and allow
curl to cool without disturbing it.

5. Continue steps 1-4 all over your head.

6. When you achieve your desired style, use
the hot brush to brush hair into place.

7. Afterward, once all curls have cooled thor­oughly, gently brush and comb hair into the
style desired.

STYLING TIPS

■ For a Flip, take a 2" section of hair and roll
the brush up over the hair.

■ For a Curl, take a 2" section of hair and roll
the brush under the hair.

■ For Volume and Body, roll hair loosely
around the brush. Allow hair to cool slightly
before brushing.

AUTO-OFF

After approximately one hour, the unit will
automatically shut itself off. To reactivate
the unit, press ON/OFF switch.

DUAL VOLTAGE USE

This product contains a special electronic circuit.
This circuit automatically adjusts to worldwide
voltage. When traveling overseas, this product
can be plugged into any voltage outlet without
your having to adjust the product manually in any
way. In some overseas countries, an attachment
plug adapter of the proper configuration for the
power supply receptacle may be required. DO
NOT USE a voltage converter or extension cord
with this product.

USER MAINTENANCE
INSTRUCTIONS

1. To clean the unit, be sure it is cool
and unplugged. Wipe handle,
barrel and curling brush with a
damp cloth. No other maintenance
is necessary.

2. When not in use, store appliance
where it will not become damaged.

Do not wrap cord around
appliance.

3. Do not attempt to repair the appliance
yourself. Return to Remington
Customer Service Center for repair.

STORAGE:

When not in use, unplug the unit. Allow it
to cool and store out of reach of children in
a safe, dry location.

Never wrap the cord around the appliance
as this will cause the cord to wear prema­turely

and break. Handle cord carefully
and avoid jerking it, twisting or straining it,
especially at plug connections.

Maintenance

P

ROTECT&SHINE

Curling Brush and Iron
with 3X Protection

+Ceramic

Ions

+

for beautiful, healthy,

Use & Care Guide

shiny hair

®

TM

CB-75i

IMPORTANT

SAFEGUARDS

When using electrical appliances, especially when children are
present, basic safety precautions should always be followed,
including the following:

READ ALL INSTRUCTIONS

BEFORE USING.

KEEP AWAY FROM WATER.

DANGER!

As with most electrical appliances, electrical parts are electrically
live even when the switch is off.

TO REDUCE THE RISK OF DEATH BY ELECTRIC SHOCK:

1. Always unplug this appliance immediately after using.

2. Do not use while bathing or in a shower.

3. Do not place or store appliance where it can fall or be pulled
into a tub or sink.

4. Do not place or drop in water or other liquid.

5. Do not reach for an appliance that has fallen into water.
Unplug immediately.

WARNING

TO REDUCE THE RISK OF BURNS, ELECTRIC SHOCK, FIRE,
OR INJURY TO PERSONS:

1. This appliance is for household use only.

2. An appliance should never be left unattended when plugged in.

3. Close super vision is necessar y when this appliance is used
by,on,or near children or invalids.

4. Use this appliance only for its intended use as described in
this

manual. Do not use attachments not recommended by

Remington.

5. Never operate this appliance if it has a damaged cord or plug;
if it is not working properly; if it has been dropped, damaged,
or dropped into water.Return the appliance to the Remington
Customer Service Center for examination and repair.

6. Keep the cord away from heated surfaces. Do not wrap the

cord around the appliance.

7. Never block the air openings of the appliance or place it on a
soft surface, such as a bed or couch,where the air openings
may be blocked. Keep the air openings free of lint, hair,etc.

8. Never use while sleeping.

9. Never drop or insert any object into any opening.

10. Do not use outdoors or operate where aerosol (spray) products
are being used or where oxygen is being administered.

11. This curling brush is hot when in use. Do not let eyes and bare
skin touch heated surfaces.

12. Do not place the heated unit directly on any surface while it is
hot or plugged in.

13. This appliance has a polarized plug (one blade is wider than the
other).As a safety feature,this plug will fit in a polarized outlet
only one way.If the plug does not fit fully in the outlet,reverse
the plug. If it still does not fit,contact a qualified electrician.Do
not attempt to defeat this safety feature.

14. Do not use with a voltage converter,or extension cord.

KEEP AW AY FROM CHILDREN

SAVE THESE

INSTRUCTIONS

Thank you for purchasing the Remington
Professional Curling Brush and Iron. This unique curl­ing brush and iron combines optimum styling features
with an exclusive Tefon
Ions to provide your hair the ultimate protection and
superior shine. Please carefully read the instructions
contained in this leaflet, and keep them in a safe place
for future reference.

®

plus Ceramic coating and

Key Features

3X Protection: Protect & ShineTMproducts from
Remington
Ceramic coating and Ions for the ultimate defense
against damage – for superior shine.

Teflon

through any type of hair, preventing static, sticki­ness and build-up of mousses, gels, and hair
sprays for smooth, shiny results – every time!

Ceramic coating: Ceramic protects against
damaging hot spots with high, even heat to lock
in moisture and create long-lasting styles.

Ionic conditioning: Negative ions are created,
which neutralize positive ions to reduce static and
the “frizzies”, leaving your hair looking shiny and
healthy.

®

have an exclusive Teflon®plus

®

coating: Non-stick Teflon®coating glides

®

1

*

3

2

*

*

10

*

*

4

*

*

*

5

6

*

1. Cool tip

2. Curling brush

3. Barrel with plus Ceramic
coating

4. Ions

5. LO (1) to HI (30) temperature control

6. Power indicator and ready light

7. ON/OFF switch

8. Hang-up loop

9. Tangle-free swivel cord

10. Safety stand

Product Featur es

Line Cord Safety Tips

1. To insert plug, grasp it firmly and
guide it into outlet.
NOTE: This appliance has a polar­ized plug (one blade is wider than the
other). As a safety feature, this plug
will fit in a polarized outlet only one
way. If the plug does not fit fully in
the outlet, reverse the plug. If it still

7

8

9

does not fit, contact a qualified elec­trician. Do not attempt to defeat this
safety feature.

2. To disconnect the appliance, grasp
plug and remove it from outlet.
Do not pull or yank on the cord
or appliance. Do not wrap the cord

around the unit.

NOTE: Before each use, inspect the line

cord for cuts and/or abrasion marks. If
any are found, the appliance should be
serviced and the line cord replaced.
Please return it to Remington Customer
Service for repair. DO NOT OPERATE

THE APPLIANCE IF THE LINE CORD
SHOWS ANY DAMAGE.

IMPORTANT

During the first few minutes of initial use,
there may be a slight odor. This is normal
and will quickly disappear.

How to Use

Full Two-Year Warranty

Remington Products Company, L.L.C.
warrants this product against any defects
that are due to faulty material or work­manship for a two-year period from the
original date of consumer purchase. This
warranty does not include damage to the
product resulting from accident or misuse.

If the product should become defective
within the warranty period, we will repair it
or elect to replace it free of charge. We
will return your product, transportation
charges prepaid, provided it is
delivered prepaid to: Remington Products
Company, L.L.C., 60 Main Street,
Bridgeport, CT 06604, Attention:
Customer Service Department. Include a
letter indicating the reason for return.

REMINGTON SHALL NOT BE
RESPONSIBLE FOR ANY INCIDENTAL,
SPECIAL OR CONSEQUENTIAL
DAMAGES.

This warranty gives you specific legal
rights and you may also have other rights
that vary from state to state. Some states
do not allow the exclusion or limitation of
incidental, special or consequential
damages.

W arranty Service

Remington®Money Back Offer

If within 30 days after you have purchased your
Remington
would like a refund, take back the product and
sales slip indicating purchase price and date of
purchase to the retailer from whom the product
was purchased. Remington
retailers who accept the product within 30 days
from the date of purchase. If you have any
questions concerning the money back
guarantee, please call 800-736-4648 in the U.S.

콯

Remington and Protect & Shine are trademarks of Remington Products Company,L.L.C.
license by Remington Products Company,L.L.C.

© 2003 R.P.C.,L.L.C. Job #WPC03-123 11/03 Part No.15064

Remington Products Company,L.L.C.
60 Main Street
Bridgeport, CT 06604

MADE IN CHINA

®

product, you are not satisfied and

®

will reimburse all

Visit us at www.remington-products.com
Questions or Comments:

Please call 800-736-4648 in the U.S.
This product is Listed by Underwriters

Laboratories, Inc.and bears the mark.

120-240 VAC 50/60Hz

is a registered trademark of E. I. du Pont de Nemours Company and is used under