Warning: When the hair dryer is used in a bathroom, unplug
it after use since the proximity of water presents a hazard
even when the hair dryer is switched off.
When using electrical appliances, especially when children
are present, basic safety precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
KEEP AWAY FROM WATER
DANGER – As with most electrical appliances, electrical
parts are electrically live even when the switch is off.
To reduce the risk of death by electric shock:
• Always unplug it immediately after using.
• Do not place or store an appliance where it can fall or be
pulled into a bath or sink.
• Do not use while bathing.
• Do not place or drop into water or other liquid.
• If an appliance falls into water, “unplug it” immediately. Do
not reach into the water.
For additional protection, the installation of a residual
current device (RCD) with a rated residual operating current
not exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your electrical contractor for
advice.
WARNING – TO REDUCE THE RISK OF BURNS,
ELECTROCUTION, and FIRE, OR INJURY TO PERSONS.
• An appliance should never be left unattended when plugged in to a
power outlet.
2
Page 3
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given close
supervision or instruction concerning use of the appliance by a person
responsible for their safety. This appliance is not a toy. Children
should be supervised to ensure they do not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
• Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by Remington.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agents or similarly qualified persons in order
to avoid a hazard.
• Never block the air openings of this hair dryer or place it on a soft
surface, such as a bed or couch, where the air openings may become
blocked. Keep the air openings free of lint, fluff and hair.
• Do not use on people who are sleeping.
• Never drop or insert any object into any opening of this appliance.
• Do not use outdoors or where aerosol (spray) products are being used
or where oxygen is being administered.
• Do not direct hot air towards the eyes or other heat sensitive areas.
• Attachments, where provided, may be hot during and after use.
Allow them to cool before handling.
• When using the appliance, keep your hair away from the air inlet grille.
Do not let your hair get drawn into the appliance.
SAVE THESE INSTRUCTIONS
3
Page 4
AC4001AU SHINE REVIVAL HAIR DRYER
Use & Care Instruction Manual
Thank you for purchasing your new Remington® Shine Revival blow drying kit. This
hair dryer has a powerful 2300 watt, AC motor with superior high velocity airflow
and includes styling accessories to create a salon professional blow dry at home.
1
2
3
8
9
1011
KEY PARTS
1. Air outlet grille
2. Air inlet grille with removable filter
3. Professional slimline
concentrator
4. Cool shot
5. Heat settings
Low heat
Medium heat
High heat
4
5
6
7
6. Speed settings
O Off
x Low speed
X High speed
7. Hang loop
8. Round brush
9. Sectionig clips
10. Beauty pouch
11. Berber Oil shampoo and mask
4
Page 5
TRIPLE INFUSION KERATIN, ARGAN AND CERAMIC TECHNOLOGY
The Shine Revival hair dryer grille features a unique triple infusion coating. The
coating combines Keratin, Argan and Ceramic for even heat distribution for strong,
healthy, shiny hair.
CONDITIONING IONIC TECHNOLOGY
Conditioning Ionic Technology provides 90% more ions for frizz free shine*.
COOL SHOT
This hair dryer is equipped with a true cool shot, which is used to hold your hairstyle.
Press and hold the cool shot button to rapidly cool and hold your hair once it has
been styled.
HOW TO ACHIEVE A SALON BLOW DRY
STEP 1
To prepare your hair wash and condition with Berber Oil Shampoo and Mask, then
towel dry.
STEP 2
Section off hair at the base of your scalp in small sections no wider than your brush
and pin the remaining hair above using the sectioning clips.
STEP 3
Select a medium heat & high speed setting on the dryer. Beginning at the roots,
gently pull the brush on the underside of hair down through to the ends while blow
drying. Continue process on the same section of hair until dry.
STEP 4
Repeat until all of your hair is perfectly blow dried. Use the cool shot to finish and set
your style for a long lasting salon blow dry.
*vs. standard Remington hair dryer
5
Page 6
OSMO STYLING PRODUCTS
Berber Oil Shampoo with Argan Oil is a mild rejuvenating cleanser designed to infuse
the hair with essential moisture and hydration to restore vitality and enhance shine.
Berber Oil Mask with Argan oil is a nourishing hair therapy mask designed to restore
moisture and hydration leaving hair smooth, supple and manageable.
http://www.osmoikon.com.au/
USER INSTRUCTIONS
This hair dryer is equipped with a thermostat that will cycle ‘OFF’ if the temperature
exceeds the comfort level due to partially blocked air inlet or air outlet openings. In
the event that the hair dryer stops during use turn off all switches and allow the hair
dryer to cool down, at which time the thermostat will automatically reset. Before
using again, check that the air inlet and air outlet openings are not blocked. Unplug
the hair dryer and clean the openings if necessary. During use, do not block the air
openings or let your hair be drawn into the hair dryer.
MAINTENANCE
Your hair dryer is designed for household use and is virtually maintenance free.
No lubrication is needed. When cleaning becomes necessary, turn all switches
off and disconnect the hair dryer from the power outlet. To maintain peak product
performance, it is important to clean the air inlet filter at the back of the hair dryer.
To access the air inlet filter twist the rear grille anti clockwise and pull away from
the back of the hair dryer. This will release the air inlet filter. It can now be cleaned
with a soft brush or vacuum cleaner. To replace, align the two lugs on the rear grille
with the two notches at the back of the hair dryer. Push and twist in a clockwise
direction until the rear grille is locked into position. The exterior of the hair dryer can
be cleaned by wiping it with a damp cloth.
6
Page 7
STORAGE
When not in use, always unplug the hair dryer from the power outlet. Allow the
hair dryer to cool and store out of the reach of children in a safe dry place. Never
wrap the power cord around the hair dryer since this will cause the cord to wear
prematurely and break. Handle the cord carefully for long life and avoid jerking,
twisting or straining especially at the plug connections. If the cord becomes twisted
in use, periodically straighten it. You may also use the hang loop to store the hair
dryer within convenient reach, ensuring that water cannot be splashed on to it when
it is hung up.
7
Page 8
WARNING: Do not use this appliance near bathtubs, showers, basins
or other vessels containing water.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
8
Page 9
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
WARRANTY AGAINST DEFECTS
In this warranty:
Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the
Competition and Consumer Act 2010;
CGA means the New Zealand Consumer Guarantees Act 1993;
Goods means the product or equipment which was accompanied by this warranty and purcha sed
in Australia or New Zealand, as the case may be;
Manufacturer, We or us means:
1. for Goods purchased in Australia, Spectrum Brands Australia P ty Ltd
ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,
as the case may be, contact details as set out at the end of this warranty;
Supplier means the authorised distributor or retailer of the Goods that sold you the G oods
in Australia or in New Zealand; and
You means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law, or the CGA. You are entitled to a replacement or refund for
a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods
fail to be of acceptable quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and
remedies in respect of the Goods which the consumer has under either the
Australian Consumer L aw or the CGA. The original purchaser of the Goods is
provided with the following Warranty subject to the Warr anty Conditions:
3. We warrant the Goods for all par ts defective in workmanship or materials for the
period of three (3) years from the date of purchase (Warranty Period). If the Goods
prove defective within the Warranty Period by reason of improper workmanship or
material, we may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer’s instructions. This
Warranty does not apply should the defect in or failure of the Goods be attributable
to misuse, abuse, accident or non-observance of manufac turer’s instructions on the
part of the user. As far as the law permits, the manufacturer does not accept liability
for any direct or consequential loss, damage or other expense caused by or arising out
of any failure to use the Goods in accordance with the manufacturer’s instructions.
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods are included
under this Warranty only where there is a defect in workmanship or materials used.
6. The warrant y granted under clause 3 is limited to repair or replacement only.
7. Any parts of the Goods replaced during repairs or any product replaced remain the
proper ty of the manufacturer. In the event of the Goods being replaced during the
Warranty Period, the warranty on the replacement G oods will expire on the same
date as for the Warranty Period on the original Goods which are replaced.
9
Page 10
8. In order to claim under the warrant y granted under clause 3 you must:
(a) Retain this warrant y with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid freight
within the Warranty Period accompanied with (i) the legible and unmodified original proof
of purchase, which clearly indicates the name and address of the Supplier, the date and
place of purchase, the product name or other product serial number and (ii) this warranty.
9. This warrant y is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Go ods have been ser viced or other wise repaired by a person not
authorised to do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to
any industrial or commercial use of the Goods. The Goods must be connected to the
electrical voltage requirements as specified in the ratings label located on the Goods.
11. This warranty does not cover the cost of claiming under the warranty
or transport of the Go ods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands
Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Locked Bag 3004
Braeside, VIC 3195
AUSTRALIA
Customer service in Australia: 1800 6 23 118
E-mail: consumer.enquiry@remington-products.com.au
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
PO Box 9817
Newmarket, Auckland 1149
NEW ZEALAND
Customer service in New Zealand: 080 0 736 776
E-mail: info@remington.co.nz