Reliance Controls THP216 User Manual

Door Knob & Cable Alarm
Model Number: THP216

Product Description

The product is intended to assist in protecting personal belongings and property, and to act as an early warning alarm for
emergency situations or unwanted entry into a doorway. The THP216 uses high performance 3D-DVSS (Three Dimension
Digital Vibration Sensor System) to detect the slightest vibration. Upon this vibration, a loud 100 decibel alarm will sound
instantly and last for 30 seconds. The alarm will also be activated by pulling or cutting the Cable Lock or by removing the
battery compartment.

THP216 Alarm Features

•100 dB alarm

•No installation necessary

•Compact size, easy to carry

•Detachable Cable Lock allows hanging on door knob, or fastening to property such as a bicycle or briefcase.

•Panic button for instant alarm during emergency

•Vibration Sensor option can be turned off

•Battery Low indicator

•Button cell batteries included

IMPORTANT - Read and thoroughly understand the instructions and warranty prior to

using this alarm. Before using this alarm, it should be tested to ensure it functions
properly.

THP216 Alarm Components

FRONT VIEW

1. Panic Button

2. Password keypad buttons

3. Vibration Sensor ON / OFF switch

4. LED light

5. Cable Lock

6. Battery Compartment

REAR VIEW

Low Battery Indicator

The THP216 Alarm can only detect a low battery when it is ARMED. When a low battery is detected, the unit will
sound a short beep every 10 seconds indicating it is time to replace the batteries immediately.

Setting up the THP216 Alarm

INSTALLING THE BATTERIES

Using a miniature Phillips head screwdriver, remove the screw from the battery compartment. Install the 3 x LR44 (or
similar) batteries, making sure they are installed with the correct polarity. (See figure 1) You should hear 2 beeps once the
batteries are installed, indicating the batteries are installed properly.

SETTING UP A PASSWORD

1. Press the PANIC BUTTON (RED “P”) key ONCE on the keypad. (You will hear an immediate beep as you press any
number on the keypad). The LED light will flash once every 3 seconds for a total of around 10 - 12 seconds.

2. Enter the default password of “1234”. You will then hear 2 quick beeps, indicating you should enter the NEW
password.

3. Enter a new 4-digit password. You will then hear 3 quick beeps, indicating the new password was saved.

NOTE: You only have about 10 seconds to enter the default password, then another 10 seconds for the new password. If
10 seconds passes without entering a 4-digit password on either of these steps, the light will stop flashing and you will
have to repeat the process (Step 1 – 3). If you press the wrong number at any time during password entry, press the “P”
button to clear your entry, and then enter the desired password. You could also wait 10 seconds until the light stops
flashing, and repeat steps 1-3 at any time.

CHANGING YOUR PASSWORD

1. Press the PANIC BUTTON (RED “P”) key on the keypad. (You will hear an immediate beep as you press any number
on the keypad). After pressing the PANIC BUTTON once, the LED light will flash every 3 seconds.

2. Enter the current password. You will then hear 2 quick beeps, indicating you should enter the NEW password.

3. Enter a new 4-digit password. You will then hear 3 quick beeps, indicating the new password was saved.

RESETTING YOUR PASSWORD

1. If you forgot the password, it can be reset.

2. Remove the battery for 2 minutes, and it will reset the password to the default of “1234”.

3. Follow the steps “SETTING UP A PASSWORD”.