REI ST-1000 Installation And Operatioin Manual

8

SPECIFICATIONS

AUDIO SECTION
Power supply voltage (negative ground) ……………….………….12V DC (10V-18V)
Standby Current…...………………………..…………..…………………………25mA
Max Current Consumption……….……………………….……….….………. …..7.5A
Speaker impedance …………………….……………….……… 4-8 Ohms per channel

POWER OUTPUT
Continuous Output into 4, 20 to 20,000 Hz at 10 % THD …..…...………2 x 20Watts
Maximum Power Output (Volume control Maximum)……….…...…50W×2 (at 1kHz)

FM TUNER
Range ……………………………………………………..….(USA) 87.5 – 107.9 MHz
(EUR) 87.50 – 108.00 MHz
Usable Sensitivity (S/N = 30dB)……………………………...7.34dBf.(0.6uV/75ohms)
Signal to noise ratio ………………………………….…………………...58dB (Mono)
Stereo separation (@ 1K Hz) ………………………….………...……….……..…42dB

AM TUNER
Range …………………………………………………..…….…(USA)530 – 1,710 kHz
(EUR) 522 – 1,620 kHz

Usable Sensitivity (S/N = 20dB)………………………..…………....23dBuV (14.4uV)

Signal to noise ratio (LEVEL60dbuV)…….……………….......………………... 60 dB

WEATHER BAND TUNER
Range …………………………………………………..……….162.400 –162.550MHz
Usable Sensitivity (S/N = 20dB)……………………..…………………0.7uV(-9dBuV)
Signal to noise ratio (LEVEL40dbuV)…….…………………...………………….42dB

AUXILIARY INPUT SPECIFICATIONS
Input Voltage Maximum Voltage…………………………………………………...2.0V
Input impedance…………………………………………………………………..10K

DIMENSIONS

Chassis (W x H x D) …………………………………....………….. 178 x 50 x 72 mm

Nosepiece (W x H x D) ……………………………….….…………. 188 x 58 x 13mm
Weight ………………………………………………….…………………….…. 15.8oz

*Due to continuous product improvement, specifications and design are subject to
change without notice.

Radio Engineering Industries, Inc.

www.radioeng.com

Rev A Date: 4-17-12

Heavy Duty Compact AM/FM Stereo Weather Band Radio

w/Front-Panel Auxiliary Input

Installation/ Operation Manual

50W x 2 ST-1000

2

Thank you for purchasing the ST-1000 AM/FM Weather Band Receiver from REI.
This product is designed and tested to withstand temperature and vibration extremes.
Please read the owner’s manual carefully before attempting to install this unit.

If you have an installation question or need installation assistance, please call the:

SERVICE HOT LINE

1-877-726-4617 Toll Free USA & CANADA

1-402-339-2200

FEATURES:

Non-volatile memory back-up
NOAA® Weather Band Receiver
AM/FM Stereo Receiver
Small Compact Chassis
Digital Tune and Seek
Preset Up to 30 Radio Stations (18 FM, 12 AM, 7 WB)
Front Aux Input (3.5mm Stereo jack)
Volume Select Knob
Electronic Bass, Treble, & Balance control
LED Backlighting
Output Power 50W x 2

IF ADDITIONAL INSTALLATION COMPONENTS ARE NECESSARY, CONTACT YOUR REI
SALES REP FOR:
** OEM /FACTORY WIRING HARNESS ADAPTERS
** ANTENNAS & ANTENNA ADAPTERS
** SPEAKERS & GRILLS

Radio Engineering Industries, Inc.

6534 “L” Street

Omaha, Nebraska 68117

www.radioeng.com

7

Radio

Din Collar

Din Collar

Bend tabs both top

and bottom of Din Collar

to secure

Dash

INSTALLING THE RADIO

1. Place the DIN collar into the dash opening. Bend the tabs outward as shown on
the drawing below to lock into place.

2. Connect to the radio’s harness and antenna jack. Verify clearance; then gently
insert the radio into the DIN Collar until both sides lock

.

3. To remove the radio, insert the two release keys on either sides of the radio and pull
the radio out.