Page 1
Underbar Sink
Assembly Instructions
TOOLS REQUIRED
Allen wrench (included)
PARTS:
A
(1) Sink
B
(4) Legs
C
(16) Tightening Screws
D
(1) Drain Connection
A
B C D
Assembly Instructions
1. Place the underbar sink body (A) upside down
on a surface that will not scratch it.
2. Slide the cross braces onto the legs (B) and
tighten all set screws (C). Skip this step if your
model is with galvanized legs.
D
C
A
3. Insert legs into the sink body gussets. You
may be required to loosen a set screw if one
struggles to go in.
4. Tighten all set screws and place the sink right
side up.
5. Adjust the feet as needed to meet your height
requirements or to compensate for uneven
ooring.
6. Insert drain connection (D) into sink body.
Remove any protective lm.
WARNING! Risk of personal injury. Stainless steel
edges are sharp and can cause cuts. Wear gloves
during installation and handle with care.
www.RegencyTablesandSinks.com
B
Loading...