Page 1
Guardian Expandable Gate
MODEL NO: 0724 & 0732
Owner’s Manual
12/20/13_BL
READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE
OF GATE. KEEP INSTRUCTIONS FOR FUTURE USE.
www.regalo-baby.com
...........................................................................
Regalo International, LLC.
3200 Corporate Center Drive, Suite 100
Burnsville, MN 55306-9803, USA
Toll Free: 866-272-5274
Made in China
Page 2
Page 3
Assembly and Installation Instructions
Read and follow all instructions carefully to ensure that your gate is properly installed.
Improper installation could result in the gate becoming unstable or dislodged from
the doorway. The safety of your child is your responsibility. Please keep these
instructions for your reference.
Intended for young children aged 6 months through 24 months.
Check the gate regularly to see if all the hardware and mountings
are tightened.
To prevent serious injury or death, securely install gate or
enclosure and use according to manufacturer’s instructions.
Never use with a child able to climb over or dislodge the gate or
enclosure.
Never leave child unattended.
Use only with the locking/latching mechanism securely engaged.
Contact Regalo for questions and replacement parts.
If in doubt about the use of your gate, call our customer care line 866-272-5274.
Regalo International, LLC.
3200 Corporate Center Drive, Suite 100
Burnsville, MN 55306-9803, USA
Made in China
1
Page 4
Installing your Expandable Gate:
Step 1: Place your expandable gate in an opening no smaller than 26 in. and
no larger than 42in. wide.
Hint- If the opening has a baseboard or molding near the floor, be sure to
place the gate above the molding so that the gate is installed on a vertically
even surface.
Step 2: With one hand on each side of the gate, pull each end of the gate
away from the center, until the gate spans the entire length of your doorway or
opening. As shown in Diagram A.
Diagram A
PULL
Note- Hold the outside frame of the gate, NOT the inner round bars. As shown
in Diagram B.
Diagram B
2
Page 5
Adjustment Device
Locking Pin
Horizontal Bar
Diagram C
Step 3:
Adjustment Device towards the center of the gate. As shown in Diagram D.
To lock the gate into position, pull up on the Locking Pin and slide the
Diagram D
1. LIFT
2. SLIDE
Turning Knob
Step 4: When the Adjustment Device can go no further, push down on the
Locking Pin. The pin will insert into one of the holes on the Horizontal Bar and
secure the Adjustment Device in place. As shown in Diagram E.
Diagram E
PUSH
3
Page 6
Step 5: Use the Turning Knob to tighten and secure the gate in place. Rotate
the knob away from you (clockwise) until enough pressure is created to stabilize
and secure your gate. As shown in Diagram F.
Diagram F
Turning Knob
Attention: Test the gate to make sure it is tightly secured and cannot be
easily pushed out.
Once the gate is secured in place, it is ready to use!
4
Page 7
To Remove Your Expandable Gate:
Step 1: Start by rotating the turning knob towards you (counterclockwise).
This will alleviate the pressure.
Step 2: Lift up on the locking pin and slide the adjustment device away from
the middle of the gate.
Step 3: With Both hands on the outer frame of the gate, slide the panels
inward and remove the gate from your doorway or opening.
Care and Maintenance
Periodically check the gate for signs of damage, wear, or missing components.
Do not use if any parts are missing, worm, or damaged.
Check the gate regularly to make sure all hardware and mountings are tight and
secure.
Do not use abrasive cleaners or bleach to clean your gate.
Clean your gate by sponging it with warm water and a mild detergent.
Wipe it dry immediately after cleaning.
90 Days Limited Warranty:
If, during the first 90 days after consumer purchase of this item, under
reasonable and non-commercial use and conditions of maintenance, it fails
while owned by the original purchaser because of the quality of materials or
workmanship of finish and assembly, Regalo International will replace or repair
it at Regalo’s option. PROOF OF PURCHASE REQUIRED.
5
Page 8
Replacement Parts Available
In the event of any damage or breakage, the following replacement parts are
available for order by contacting Regalo Customer Service.
Round Rubber Bumper
Contact Regalo for questions and replacement parts.
For questions about the use of your gate, call our customer care line 866-272-5274.
Regalo International, LLC.
3200 Corporate Center Drive, Suite 100
Burnsville, MN 55306-9803, USA
Made in China
(#11058)
6
Page 9
Regalo International, LLC.
3200 Corporate Center Drive, Suite 100
Burnsville, MN 55306-9803, USA
Toll Free: 866-272-5274
Made in China
12/20/13_BL
Loading...