Regalo 2772 User Manual

FOR THE MOST IMPORTANT PEOPLE

IN THE WORLD

TM

TRAVEL DINER

PORTABLE HOOK–ON HIGH CHAIR

Models: 2772
Owner’s Manual
06/21/2013_DC

• READ ALL INSTRUCTIONS BEFORE ASSEMBLY
AND USE OF CHAIR.

• KEEP INSTRUCTIONS FOR FUTURE USE.

www.regalo-baby.com

...........................................................................

Regalo International, LLC.

3200 Corporate Center Drive, Suite 100

Burnsville, MN 55306-9803, USA

Toll Free: 866-272-5274

Made in China

Failure to follow these warnings could result in serious injury or death.

• Be sure hook–on chair is securely attached to table before seating child.

• The child should be secured in the hook–on chair at all times by restraining
system.

• Never leave child unattended. Always keep child in view when in hook–on chair.

• Check stability of table before and after seating child.

• Do not use on a glass, or a loose tabletop, table leaf, or single pedestal or card
table, or with table cloths or placemats.

• Discontinue use if hook–on chair is broken. Contact manufacturer immediately for
replacement parts or service.

• Do not place an ordinary chair under this hook–on chair or position this hook–on
chair on counters or tables which are near other structures that could be used by the
child to push the hook–on chair off or up from the table or counter.

• Do not use without all tips (suction cups or other locking/latching mechanisms)
attached securely to table surface.

• Keep seat and table surface clean and dry to prevent seat from slipping.

• Use only for a child capable of sitting upright unassisted.

• Discontinue use if child, when seated in hook–on chair, is able to move the
hook–on chair arms on the table top.

• Do not allow other children or animals to play near or walk under hook–on chair
while in use.

• Use only for children up to 37 pounds (16.8kg).

• Use only for tables 1 to 2 inch. thick (25 - 51mm).

• Before removing child from hook–on chair, be sure child’s legs are free from
hook–on chair supports.

• Always ensure that all hazards such as electrical devices, knives and hot liquids
are kept out of reach of the child in the chair.

• Do not hang objects from the chair.

• Do not use the table seat for more than one child at a time.

• Do not use table cloths or other objects on the surface of the table top which may
interfere with the function of the securing mechanism.

1

READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE
OF CHAIR. KEEP INSTRUCTIONS FOR FUTURE USE.

ASSEMBLING YOUR TRAVEL DINER CHAIR

1.Remove the black plastic protective caps from the ends
of the backrest bar. These black plastic caps are for packing
purpose only and should be discarded.
If the backrest bar (U – shaped) is not fitted, slide the arm
through the sleeve at the back of the seat cover until the
pins on the tube are exposed on either side of the sleeve.

2.Assess the position of each arm. For the correct position
of each arm you must have:
a.Round rubber stopper positioned at front.
b.Round lock release button on clamp must face the
outside of the chair.
c.Rubber paddle – grip positioned at top.

2

3.Slide each paddle-grip through the cover of each sleeve
located on the side of the seat. Insert from the back of the
sleeve and push the arm through.
*Remember, the lock release button on the clamp must
facing to the outside.

4.Remove the black plastic protective caps from the
openings of both arms and discrad them. The caps are only
for packaging purposes. Next, attach both arms onto the
backrest bar, pushing the spring pin in, as you slide the
arms over the backrest bar.

3

TIPS FOR INSTALLING YOUR TRAVEL DINER CHAIR

Step 1.

Make sure the two locks (H) are angled forward (see the
position in Diagram (1). Press in the lock release button(D)
to do this. Fit onto a table or suitable flat surface as shown
in Diagram (1)

Diagram 1

(H)

(D)

Step 2.
Install the Travel Diner on the table top as shown in the
Diagram 2a. Then, push down on the back of the Travel
Diner as indicated by the arrow in Diagram 2b, until the
seat is almost level with the table top . Next, pivot the
locks back until they automatically lock in the vertical
position as shown in Diagram 2c.

Diagram 2a

Diagram 2c

Diagram 2b

4

Step 3.
To lock your Travel Diner onto the table, continue pushing
down on the back of the Travel Diner and at the same time
turn the plastic locking knobs ( J ) clockwise as indicated by
the arrow in this diagram 3. Continue turning the locking
knobs until they are tight against the bottom of the table
surface. Your Travel Diner should now be securely locked to
the table top. If properly locked to the table top, you should
not be able to pull your Travel Diner off the table, even
when pulling with a reasonable amount of force.

(J)

Diagram 3

HARNESS INSTRUCTIONS

To secure your child in the harness, push buckle tongues (A)
into buckle housing (B) and adjust with waist strap adjuster
so that the waist strap is firmly secured around child.
Attach shoulder straps in position on buckle tongues (A) and
adjust so that they are secure, yet comfortable on child.

Adjuster

Adjuster

Strap

Waist Strap

Adjuster

Buckle Housing (B)

Buckle

Tongue (A)

Clips

Buckle

Tongue (A)

Waist Strap

Adjuster

5

CLOSING THE TRAVEL DINER CHAIR

Before attempting to close the Diner Chair, remove your
child. Loosen the table locks on the Diner Chair arms.
Press in the lock release buttons and angle the table locks
forward. Remove the Diner Chair from the table. Fold the
Diner Chair seat arms inward to store the Diner Chair.

CARE AND MAINTENANCE

Periodically check the Diner Chair for sign of damage, wear or
for missing components. Do not use if any part is missing,
worn of damaged. Always dry metal parts to avoid the
formation of rust. Regularly check the securing screws to
ensure that they are securely tightened and tighten when
necessary.

FABRIC CARE

Always check the strength of the fabric and the strength of
the stitching each time the fabric is washed.

90 Days Limited Warranty:

If, during the first 90 days after consumer purchase of this item,
under reasonable and non-commerical use and conditions of
maintenance, it fails while owned by the original purchaser because
of the quality of materials or workmanship of finish and assembly,
Regalo International LLC will replace or repair it at Regalo’s option,
proof of purchase required.

If you have any questions or comments contact:

Regalo, International
Toll free: 866-272-5274
http://www.regalo-baby.com
Made in China.

6

Regalo International, LLC.

3200 Corporate Center Drive, Suite 100

Burnsville, MN 55306-9803, USA

Toll Free: 866-272-5274

Made in China

06/21/2013_DC