Page 1
FLEXI GATE
MODEL NO: 1175
Owner’s Manual
01/09/2014_EV
READ ALL INSTRUCTIONS BEFORE ASSEMBLY
AND USE OF GATE.
KEEP INSTRUCTIONS FOR FUTURE USE.
www.regalo-baby.com
...........................................................................
Regalo International, LLC.
3200 Corporate Center Drive, Suite 100
Burnsville, MN 55306-9803, USA
Toll Free: 866-272-5274
Made in China
Page 2
Page 3
Assembly and Installation Instructions
Read and follow all instructions carefully to ensure that your gate and extensions are
properly installed. Improper installation could result in the gate becoming unstable or
dislodged from the doorway. Always make sure extensions is securely attached to the
gate before using. The safety of your child is your responsibility. Please keep these
instructions for your reference.
WARNING:
Intended for young children aged 6 months through 24 months.
Check the gate regularly to see if all the hardware and mountings
are tight.
To prevent serious injury or death, securely install gate or
enclosure and use according to manufacturer’s instructions.
Never use with a child able to climb over or dislodge the gate or
enclosure.
Never leave child unattended.
Use only with the locking/latching mechanism securely engaged.
To prevent falls, NEVER used at the top of stairs.
The four Wall Mounting Brackets must be used in securing the
gate to the wall. These brackets prevent the gate from dislodging
from its opening and becoming unstable.The maximum width
opening for the gate is 76 inches.
Contact Regalo for questions and replacement parts.
If in doubt about the use of your gate, call our customer care line 866-272-5274
Regalo International, LLC
3200 Corporate Center Drive, Suite 100
Burnsville, MN 55306-9803, USA
Made in China
1
Page 4
Check to make sure you have all of the parts shown:
A.
B.
A. Folded Gate Frame and attached Wall Mounting Assembly
B. 8 Wall Mounting Screws
ADITIONAL EXTENSIONS SOLD SEPARATELY!
2
Page 5
Step 1.
Begin by unfolding the gate frame. To do this, simply loosen the Locking Knobs
at each pivoting joint by turning the knob counter clockwise as shown in Diagram A.
Loosen the knobs enough to allow the gate to swing open freely without fully
removing the knobs.
Locking Knobs
Diagram A
Step 2.
Bring the Wall Mounting Bracket to the wall you intend to attach it to as shown in
Diagram B.
Diagram B
Wall Mounting Bracket
3
Page 6
Step 3.
Use a Phillips/crosshead screwdriver to fix the Wall Mounting Bracket to the Wall as
shown in Diagram C
Diagram C
Step 4.
Repeat steps 2 & 3 on the other end of the gate. Arrange the panels into your desired
configuration, then tighten each of the Locking Knobs.
Care And Maintenance
Periodically check the gate for signs of damage, wear, or missing components.
Do not use if any part is missing, worn or damaged.
Check the gate regularly to ensure all the hardware and mountings are
tightened.
Do not use abrasive cleaners or bleach.
Clean by sponging with warm water and a mild detergent.
90 Days Limited Warranty:
If, during the first 90 days after consumer purchase of the item, under
reasonable and non-commercial use and conditions of maintenance, it fails
while owned by the original purchaser because of the quality of materials or
workmanship of finish and assembly, Regalo International LLC will replace or
repair it at Regalo’s option. PROOF OF PURCHASE REQUIRED.
4
Page 7
Replacement Parts Available
In the event of any damage or breakage, the following replacement parts
are available for order by contacting Regalo Customer Service.
Bracket
(#12005)
Locking Knob
(#10001)
Wall Mount Screws
(#12003)
Toothed Disk
(#12011)
Top Hinge
(#12013)
Wall Mount
Toothed Disk
(#12007)
Wall Mount
(#12009)
Door Frame
Toothed Hinge
(#12008)
29”Metal Pivot Bar
(#12002)
Bottom Hinge - Male
(#12004)
Door Frame Bottom Hinge
(#12014)
Cap - Female
Wall Mount Bottom
Page 8
Regalo International, LLC.
3200 Corporate Center Drive, Suite 100
Burnsville, MN 55306-9803, USA
Toll Free: 866-272-5274
Made in China
01/09/2014_EV
Loading...