Reese 44173 User Manual

SERIES 51®

Hitch Shown In Proper Position

Fascia

Installation Instructions

Dodge Durango Chrysler Aspen

Do Not Exceed Lower of Towing Vehicle

Hitch type

Weight Distributing

Weight Carrying

Ball Mount

Manufacturer’s Rating or

Max Gross

Trailer WT (LB)

Part Numbers:

51067 44173

Max Tongue

WT (LB)

750 (341 Kg)7500 (3405 Kg)

500 (227 Kg)5000 (2270 Kg)

Equipment Required: Pull wire (Provided), “C” Clamp

Fastener Kit: 51067F

Wrenches: 7/8

Drill Bits: 1/2”

Holes (4) to be drilled

Cut away views

1. Lower spare tire.

2. Remove the (4) fasteners which secure fascia to fascia mounting brackets. Push fascia up to allow access to vehicle's crossmember.

3. Raise hitch into position and center it on vehicle.

4. Secure tightly in place with “C" clamp(s). Making sure the hitch assembly is up tight to the bottom of the vehicle's crossmember.

5. Using the hitch as a guide, drill (4) holes (1/2 inch dia.) into the crossmember. Note: Install the hardware into the holes that are closest to the middle of the vehicle first.

6. Insert pull wire (coiled end) through hitch and the drilled hole in the crossmember until the pull wire comes out the open end of the

crossmember. Slide block over the coiled end and attach carriage bolt. Carefully pull the hardware through the crossmember as shown.

7. Remove the pull wire and install lock washer and nut finger tight onto the carriage bolt. Repeat this step (3) more times to install the remaining hardware.

8. Replace the (4) fasteners which secure fascia to fascia mounting brackets that were previously removed in step number 2.

9. Raise spare tire back into position.

Carriage Bolt 1/2-13 X 1.50Qty. (4)

SpacerQty. (4)

Pull wire

Vehicle crossmember

Wiring Access Location: SUV1, SUV2

Crossmember

Figure 1

Hardware closest to the middle first

Lock Washer 1/2Qty. (4)

Hex Nut 1/2-13Qty. (4)

(See Figure 2.)

Figure 2

Tighten all 1/2-13 GR8 fasteners with torque wrench to 106 Lb.-Ft. (144 N*M)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.

z 2004, 2006 Cequent Towing Products

Form: F205 Rev A 5-6-05

Rev. E9-22-0651067NSheet 1 of 1