Reese 44051 User Manual

Equipment Required:

Fastener Kit: F33025

Wrenches: 9/16, 3/4, 18mm, 19mm, #45 Torx®

Drill Bits: None

1 2

Installation Instructions

Toyota Tacoma

Do Not Exceed Lower of Towing Vehicle

Hitch type

Weight Distributing

Weight Carrying

Ball Mount

Wiring Access Location: PU1, PU2

Frame

1 2

2 3

Manufacturer’s Rating or

Max Gross

Trailer WT (LB)

Existing 12mm bumper bracket bolt (see Note 2)

Part Numbers:

33025 44051

Max Tongue

WT (LB)

550 (250 Kg)5500 (2497 Kg)

500 (227 Kg)5000 (2270 Kg)

Frame angle bracket is inside frame on both sides

2 3

6 5

1. Remove (2) two center Torx head bolts from bottom of bumper (3/8” bolts).

2. Remove (1) one nut from existing bumper bracket bolt at location shown above.

3. Set angle bracket in place over existing bumper bolt as shown.

4. Raise hitch up to frame and align rearmost holes in frame and bracket, install 1/2” hex head bolt with 1/2 “ toothed washer through angle bracket, frame, and hitch bracket. Loosely apply 1/2” flanged locknut. This will hold receiver in place.

5. Install 3/8” hex bolt with 3/8” lock washer and 3/8” toothed washer, through strap on the end of the hitch box from bottom and into bumper where torx head bolts were removed (See diagram on other side).

6. Install 1/2” hex head bolt with 1/2” toothed washer through angle bracket, frame and hitch in forward hole in frame. Install 1/2” flanged locknut on the bolt.

7. Reinstall nuts on 12mm bumper bracket bolts.

8. It may be necessary to remove the rubber muffler hanger so that the nut above the exhaust can be torqued.

9. Tighten all fasteners.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.

Bolt 1/2-13 X 1.75Qty. (4)

Conical Washer 1/2Qty. (8)

Hex Nut 1/2-13Qty. (4)

Tighten all 1/2” fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

Tighten all 3/8” fasteners with torque wrench to 35 Lb.-Ft. (47 N*M)

Tighten all 12mm fasteners with torque wrench to 85 Lb.-Ft. (115 N*M)

Bolt 3/8-16 X 1.50Qty. (2)

Lock Washer 3/8Qty. (2)

Flat Washer 3/8Qty. (2)

z 2002, 2006 Cequent Towing Products

Rev. A6-27-06N33025Sheet 1 of 1

Form: F205 Rev A 5-6-05