Reese 38211 User Manual
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: N/A
Wrenches: 15/16”
Drill Bits: None
Chassis
Hitch (38211)
Drawbar must be used in the
Drop position only.
Installation Instructions
20K HITCH
Drawbar Kit:
38124B
Chassis
Do Not Exceed Lower of Towing Vehicle
20,000 LB (9072 Kg) Max Gross Trailer Weight
3,000 LB (1360.8 Kg.) Max Tongue Weight
Manufacturer’s Rating or
1.25
.25
6” – 6.5”
Part Numbers:
38211
38123N
20.2”
1111
2222
3333
6666
5555
7777
4.8”
27.0”
FRONT OF CHASSIS LOOKING REARWARD
2222
Both Sides
10.5”
.25
11.0”
25.4”
13.7”
6.5”
Slide hitch
against chassis.
4444
5555
3/4” Hitch Pin with Lanyard Qty. (1)
HitchQty. (1)
1111
Both Sides
Wrap Weld
Around Fillet
5555
6666
.25”
1.00”
DRIVERS SIDE OF CHASSIS LOOKING AT
THE PASSENGER SIDE
Conical Washer 5/8”Qty. (16)
Hex Bolt (5/8” – 11 x 2” Grade 8)Qty. (8)
3333
4444
1. Measure chassis width. If chassis width is under 34.75” then remove shim plates as required (Item 7). To remove shim plates:
remove fasteners (Item 4, 5 & 6). Discard spacer plates (Item 2). Reinstall fasteners and align side brackets. Snug up
fasteners.
2. Raise hitch into position. Weld hitch to chassis as shown above.
3. Torque hitch fasteners (Items 4,5 & 6) to:
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2007 Cequent Towing Products
DrawbarQty. (1)
Hex Nut (5/8” – 11 Grade 8)Qty. (8)
Tighten 5/8” – 11 Grade 8 fasteners to 190 lb.-ft. (257.6 N*M)
7777
Spacer PlateQty. (4)
Rev. D11-12-0838123NSheet 1 of 1
Form F206 Rev A 5605
Loading...