Model
Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
Black
CP-09
AC Current Adaptor
Instruction
Manual
www
reedinstruments
www.GlobalTestSupply. com
com
Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
Black
Rich Black -
20/20/20/100
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
Safety
To prevent electric shock or re carefully read all safety information before
operating this adaptor:
• Do not use this clamp on circuits rated higher than 600V in
Installation Category II
• Use caution when clamping around uninsulated conductors or bus
bars
• Do not use the clamp if it is cracked, damaged, or has a defective
cable
• Check the magnetic mating surfaces of the clamp jaws; these should
be free of dust, dirt, rust, and other foreign matter
• Keep your ngers off the clamp jaws
• Keep your ngers behind the safety barrier
Specifications
AC Current Range: 0-200A
AC Current Accuracy: ±2.0% ±0.5A
AC Current Output: 1mV/A
AC Current Sensitivity: 1A/mV AC
Output Impedance: <1kΩ
AC Bandwidth: 40 to 400Hz
Jaw Opening: 0.62” (16mm)
Operating Conditions: 32 to 122°F (0 to 50°C), 45 to 90% RH
Dimensions: 4.37 x 1.96 x 1.29” (111 x 50 x 33mm)
Weight: 4.55lb (129g)
www
www.GlobalTestSupply. com
reedinstruments
com
2
Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
Black
Rich Black -
20/20/20/100
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
Instrument Description
1. Clamp Jaw
2. Clamp Trigger
3. Safety Barrier
4. Voltage Output Lead
www
www.GlobalTestSupply. com
reedinstruments
com
3
Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
Black
Rich Black -
20/20/20/100
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
Operating Instructions
• Connect the test leads to the voltage output lead of the Clamp
Adaptor and input shock of the voltage measurement device
• Turn on the voltage measurement device and set it to AVC 200mV
or 400mV
• Position the Clamp Adaptor perpendicular to and centered around
the conductor
• Read the measured value on the voltage measurement device
For service (repairs or calibration) on this or any other REED product
or information on other REED products, contact REED Instruments at
info@reedinstruments.com
www
www.GlobalTestSupply. com
reedinstruments
com
4
Loading...