Reebok TX2.0, TC3.0 User Manual [nl]

TITANIUM CONSOLE USER GUIDE

TC2.0/TC3.0/TX2.0/TXF3.0

UK

reebokfitnessequipment.com

TC2.0/TC3.0/TX2.0/TXF3.0

CONSOLE USER GUIDE

UK

TC2.0, TC3.0, TX2.0, TXF3.0 COMPUTER

A

F

BUTTON OPERATION

DRIVE KNOB

•Rotate the i-Drive knob to adjust the setting values or resistance, turn clockwise to increase

and anticlockwise for decrease.

•Press the i-Drive knob to confirm the value and move to the next step.

QUICK START

Press to begin exercising immediately in manual mode.

START/STOP

•Press to start a program.

B

C

LCD

RESET

START/STOP

•During any exercise press to pause the program, all values will remain on the display.

E

Press again to resume.

RESET

D

•When in USER profile setting mode, press to revert to USER code selection.

•When in program set up mode or pause status, press to revert to program selection.

•Press and hold for 3 seconds, the computer will revert to power on status.

A

QUICK START

D

RECOVERY

B

C

RECOVERY

E

I-DRIVE KNOB

F

Press to enter the heart rate recovery test mode.

2

3

reebokfitnessequipment.com

TC2.0/TC3.0/TX2.0/TXF3.0

CONSOLE USER GUIDE

UK

GETTING STARTED

•When the power is switched on the computer will beep and the full screen display will be shown
for 2 seconds (Figure 1). The computer will then enter the user profile setting mode (Figure 2).

•If no use is detected for a period of 4 minutes the computer will switch off. Begin to pedal
to turn back on.

FIGURE 1



USER PROFILE SETTING

From Power on screen, rotate the i-Drive knob to select the user
(U1, U2, U3, U4, U5) press to confirm selection.

GENDER

SEX will be displayed on the right side of the screen. Select the
gender by rotating the i-Drive knob, F = female, M = male. Press
the i-Drive to confirm.

AGE

AGE will be displayed on the right side of the screen.
Select by rotating the i-Drive knob. Press the i-Drive to confirm.

AGE

FIGURE 2

•You can simply press the QUICK START button to start the workout immediately without setting the
user profiles of pre-set programs. The resistance can be adjusted by rotating the i-Drive at any time.

HEIGHT

H.t will be displayed on the right side of the screen.
Select by rotating the i-Drive knob, Press the i-Drive to confirm.

WEIGHT

W.t will be displayed on the right side of the screen.
Select by rotating the i-Drive knob, Press the i-Drive to confirm.

The computer will enter the program selection mode.

To change the user code press STOP, then press
and hold RESET button for 3 seconds to return to
power on screen.

4

5