Reebok TX 1.0 User Manual

TITANIUM CONSOLE USER GUIDE

TC1.0/TX1.0

UK

reebokfitnessequipment.com

TC1.0/TX1.0

CONSOLE USER GUIDE

UK

TITANIUM TC1.0/TX1.0 COMPUTER

A

F

BUTTON OPERATION

DRIVE KNOB

•Rotate the i-Drive knob to adjust the setting values or resistance levels, turn clockwise to increase

and anticlockwise to decrease. Resistance levels can be adjusted from L1 - L20.

•Press the i-Drive knob to confirm the value and move to the next step.

QUICK START

Press to begin exercising immediately in manual mode.

START/STOP

•Press to start a program.

B

C

LCD

RESET

START/STOP

•During any exercise press to pause the program, all values will remain on display.

E

Press again to resume.

RESET

D

•When in the USER profile setting mode, press to revert to USER code selection.

•When in program set up mode or pause status, press to revert to program selection.

•Press and hold for 3 seconds, the console will revert to power on status.

A

QUICK START

D

RECOVERY

B

C

RECOVERY

E

I-DRIVE KNOB

F

Press to enter the heart rate recovery test mode.

2

3

reebokfitnessequipment.com

TC1.0/TX1.0

CONSOLE USER GUIDE

UK

GETTING STARTED

•When the power is switched on the computer will beep and the full screen display will be shown
for 2 seconds (Figure 1). The computer will then enter the user profile setting mode (Figure 2).

•If no use is detected for a period of 4 minutes the computer will switch off. Begin to pedal
to turn back on.

FIGURE 1



USER PROFILE SETTING

From power on screen, rotate the i-Drive knob to select the user
(U1, U2, U3, U4, U5) press to confirm selection.

GENDER

SEX will be displayed on right side of screen. Select the
gender by rotating the i-Drive knob, “F” = female, “M” = male.
Press the i-Drive to confirm.

AGE

AGE will be displayed on right side of screen. Select by
rotating the i-Drive knob. Press the i-Drive to confirm.

AGE

FIGURE 2

•You can simply press the QUICK START button to start the workout immediately without
setting the user profiles or pre-set programs. The resistance can be adjusted by rotating
the i-Drive at any time.

HEIGHT

H.t will be displayed on right side of screen. Select by
rotating the i-Drive knob. Press the i-Drive to confirm.

WEIGHT

W.t will be displayed on right side of screen.
Select the weight by rotating the i-Drive knob.
Press the i-Drive to confirm.

The console will enter the programs selection mode.

To change the user code, press STOP, then press and
hold RESET button for 3 seconds to go back to power
on screen.

4

5