Red Sound Systems MicroAMP Owner's Manual
INPUT
-
POWER
micro AMP
Sound
Red
the colour of music
+
12dB
-
EQ
MIN
12dB
+
HIGH
12dB
-
LEVEL POWER
LOW
MAX
+
ON
OFF
12dB
www.redsound.com
micro amp
Issue 2
WARNING!
AVOID USING THIS PRODUCT AT HIGH VOLUME LEVEL
SETTINGS FOR EXTENDED PERIODS OF TIME!
The amplifier section of the MICRO AMP is capable of delivering very
high volume levels to the connected headphones which, if sustained
over long periods, could cause damage to your hearing. Also, the
drivers in the connected
headphones may be damaged if high output
levels are maintained.
Always use the lowest, most comfortable volume level setting to suit
the particular environment. We cannot be responsible for the
improper use of this product!
IMPORTANT NOTICE - PLEASE READ
Always ensure the battery compartment screw is fully tightened.
Noise or hum may occur if this screw is loosened.
Explanation: The metal case of the MICRO AMP acts as shielding for
the very high gain amplifier section within the product and effectively
stops any induced hum or noise pick-up.
The top panel is connected
to the base panel by the main fixing screw which acts as the
grounding connection between the two panel sections.
INTRODUCTION
Thank you for buying the RED Sound MICRO AMP headphone amplifier.
The fully portable poor headphone monitoring
performance so common in today’s mixing desks and audio equipment. This pocket - sized,
high quality audio amplifier with built-in 2 band EQ will make all the difference when it comes
to successful monitoring in the club, studio or home environment.
With straight-forward connections and simple setup, a compact case and three mounting
options, the MICRO BPM will integrate perfectly into any setup.
Please read the following sections of this manual carefully to understand the operation of
your new RED Sound
MICRO AMP is the ideal solution for
fully
MICRO AMP.
FRONT PANEL/CONNECTORS
FRONT PANEL CONTROLS AND
CONNECTORS
Here’s a quick guide to the controls and connectors
on the MICRO AMP.
AUDIO INPUT - Connector
1
Use a suitable input cable [3.5mm jack] to connect
this socket to the
your mixing desk/audio equipment.
POWER IN - Connector
2
Connect the output plug of the optional 17vDC
transformer to this socket.
3
EQUALIZATION - Rotary controls
The centre-click, High (6.5kHz) and Low (100Hz)
EQ controls can be used to cut or boost the audio
frequencies whenever adjustment is required.
4
LEVEL - Rotary control
This knob controls the output level to the
connected headphones.
5
ON/OFF - Switch
Use this switch to turn the MICRO AMP’s power on
and off (always ensure the power is switched off
when the MICRO AMP is not in use to preserve
battery life).
6
HEADPHONE OUT - Connector
Connect the plug from your headphones to this
6.3mm gold-plated output socket.
headphone monitor output on
-
+
POWER
2
1
INPUT
micro AMP
Sound
Red
the colour of music
12dB
-
3
4
EQ
MIN
12dB
+
HIGH
-
12dB
LOW
MAX
+
ON
OFF
12dB
LEVEL POWER
5
www.redsound.com
6
PAG E
1
Loading...