
IMPORTANT: SOFTWARE INSTRUCTIONS CAN BE FOUND ON THE SOFTWARE CD
First you should install the PhotoViewer software using the CD Rom included; you can also view the
PhotoViewer software instructions on the CD Rom.
To power up the DigiView Digital Key Chain press and hold the menu button for three seconds.
The battery is charged using the USB connection (cable included) to your computer and takes up to four
hours to fully charge the device, the battery lasts between 4~6 hours when fully charged.
CONTROLS AND SETTINGS
Up Key (Top Button) – Scroll pictures and menu settings
Down Key (Middle Button) – Scroll pictures and menu settings
Menu/Power up (Bottom Button) – Menu and Select button
Display Screen 1.1 inch CSTN-LCD
Power Supply
Picture format
Accessories USB cable, user manual
3.7V built-in lithium battery
Up to 6 hours play time
JPG、BMP, PNG, Gif
When the device is powered up it will display the pictures stored on its memory.
Push Menu Button once – The Menu will appear and give you the choices of:
Off = Turn device off
Photo Display Mode = Auto Slideshow or Manual Slideshow (when you select auto you then have the
option to increase/decrease transition times)
Clock Set = Set time and Date
Auto ON/OFF = Set the time to automatically turn device on and off
Clock Display = Select Water Mark to display the time on screen or Normal to switch it off
Contrast Set = Adjust Brightness
Exit = Back to photo display
IMPORTANT SAFETY INSTRUCTIONS
Please read all safety instructions:
Warning: Do not expose this product to rain or moisture.
Caution: Do not remove cover
Attachments: Other attachments and accessories are not recommended and may be a hazard.
Heat: The device should be situated away from sources of high heat such as radiators or stoves.
Power Source: The device should not be connected to any other type of power source.
Avoid Liquids: Care should be taken so that liquids are not spilled on or insid e the device.
Servicing: The user should not attempt to service the device.
Technical Support
+44 (0) 1323 508 342