Red Goat SM-12A Service Manual

OWNER'S MANUAL FOR

MODEL "SM 12"

USE AND CARE OF YOUR
ELECTRIC FOOD SLICER

General Slicing/Red Goat Disposers

1152 Park Avenue P.O. Box 428
Murfreesboro, Tennessee 37133-0428 • [phone]

FIG. 1 FIG. 2

FIG. 3

IMPORTANT! READ THIS MANUAL BEFORE USING YOUR NEW SLICER

It is important to take a few minutes to read this booklet
thoroughly before using your new slicer. This will help you obtain
the full benefits of the quality convenience and safety built into this
product. Keep this booklet in a handy location for future reference.

ASSEMBLY: Your new slicer comes to .you fully assembled and
ready for use, however even a new machine shipped directly from
the factory should be thoroughly cleaned before use to insure
sanitary conditions.

DISASSEMBLY AND CLEANING

CAUTION: BE SURE THE SLICER IS UNPLUGGED AND THE
REGULATOR KNOB IS SET AT "0" BEFORE CLEANING OR
HANDLING.

REMOVING FOOD PUSHER

1. Set thickness regulator knob to "0" position.

2. Slide platform ( 1) to extreme forward position (fig. 1 )

3. While holding food pusher shaft (2) turn lock knob (3)
counterclockwise and remove, (fig. 2)

PLATFORM REMOVAL

1. Loosen knob (4) counterclockwise about one turn. (removal
of knob not necessary), (fig. 3)

2. Grasp platform and pull straight up. (fig. 3)

FIG. 4

FIG. 5

FIG. 6

FIG. 7 REMOVAL OF KNIFE

REMOVING KNIFE SHARPENER

CAUTION: EXTREME CARE SHOULD BE USED
WHEN REMOVING SHARPENER AS THIS WILL
LEAVE A PORTION OF THE BLADE EXPOSED.

1. Grasp knife sharpener (5) by knob (fig. 4).

2. Pull straight up as far as possible. DO NOT LOOSEN
KNOB FROM SHARPENER. Turn clock wise one
quarter of a turn and pull sharpener up and away from
sheer (fig. 5).

REMOVAL OF KNIFE COVER

1. If platform is mounted on slicer slide it to the
extreme rear position away from knife.

2. While holding cover ( 6 ) loosen and remove lock ing

knob (7) by turning it counterclockwise (fig. 6-7).

3. Push threaded stud in and remove cover.