Page 1
FAN LIGHT KIT
Product images may vary slightly from actual product.
INSTRUCTION MANUAL
Page 2
Page 3
INSTALLING THE LIGHT KIT
REMEMBER to turn o the power before you begin.
Step 1. Remove and discard the center plug from the switch
housing. Attach the light kit to the switch housing by feeding the
light kit wires (black and white) through the hole in the center of the
switch housing, then screw the light kit onto the switch housing.
Attach the lock washer & nut on the inside of the switch housing
making sure the light kit is secure to prevent movement after
installation. (Fig. 1)
Nut
Lock washer
Switch housing
Center plug
Light kit
Step 2. Locate the white and blue wires inside the switch housing
labeled FOR LIGHT.
Step 3. Attach the wires from the light kit to the wires inside the
switch housing by pushing the polarized connections together.
- White wire to White wire
- Blue wire to Black wire
Step 4. Raise and hold the light kit assembly close to the mounting
plate of the ceiling fan. Push the square wire connectors together.
(Fig. 2)
NOTE: The square connectors are color coded. Match the color
coded sides of each plug and push. They will attach ONLY when
matched correctly.
Step 5. Carefully push all wires back into the switch housing, then
install the light kit assembly onto the mounting plate with 3 screws
provided. Be sure to tighten all screws. (Fig. 2)
4 |
Fig. 1
Mounting plate
Square connectors
Light kit
assembly
Fig. 6
Screws
Fig. 2
Page 4
INSTALLING THE LAMP &
GLASS SHADE
1. Install the7 watt E26 LED lamp (provided) to the fixture socket.
2. Attach the glass shade to the light fixture by turning the glass shade
clockwise. DO NOT OVER TIGHTEN. (Fig. 3)
3. Your installation is now complete. Restore electrical power and
enjoy your new ceiling fan light fixture.
Turn the power on and check the operation of your light fixture.
The pull chain controls the light On-O.
Light kit
assembly
Lamp
Glass shade
Fig. 3
FAN LIGHT KIT | 5
Loading...