Red Barrel Studio W006112412 Installation & Assembly

Bathroom Wall Cabinet

Left Side Panel

Front Top Rail

Fixed Shelf

Back Panel

Right Side Panel

Left Door

Back Top Rail

Bottom Panel

Right Door

Back Bottom Rail

Top Panel

Support Plate

Drawer Front Panel

Drawer Back Panel

Drawer Side Panel

Drawer Bottom Panel

Cam Lock Ø15*12mm

Knob Ø29*27mm

Cam Bolt Ø6*42mm

Round Head Bolt

Ø5/32"*19mm

Wood Dowel Ø8*30mm

Long Screw Ø4*57mm

Short Screw Ø3.5*25mm

Drawer Stopper Ø29*27mm

Magnet L70*H12mm

Screw Ø3*12mm

Screw Ø3*15mm

Wall Anchor Ø8*38mm

F X 1

G X 1

Note: It is not recommended to use power tools during assembly. You may use power
tools to assist in mounting the safety strap kit to the wall.

Phillips Head Screw Driver

Attach Knob (D) to Doors (10 & 11) using Round Head Bolt (E) .
Attach Magnet (H) exactly as shown.

Attach Magnet (H) exactly as shown

Fix Cam Bolt (B) to Side Panels (1 & 7) ,Bottom Panel (8) and Top Panel (9),as shown .

Attach Drawer Stopper (J) exactly as shown.

Attach Drawer Stopper (J) exactly as shown

Set Drawer Front Panel (13), Drawer Side Panels (14) , Drawer Bottom Panel (15) and Drawer
Back Panel (16) into place using Short Screw (G) .
Attach Knob(D) to Drawer Front Panel (13) using Round Head Bolt (E) .

Attach Rail (2 & 5 & 6) and shelf (3) to Right Side Panel (7) using Wood Dowel (C) and
Cam Lock (A) .
Set Left Side Panel (1) into place using Wood Dowel (C) and Cam Lock (A) .

Set Top Panel (9) into place using Cam Lock (A) .

Place Top Panel (9) to the ground and insert Back Panel (4) into cabinet .

Note:Insert Back Panel exactly as shown.

9

Set Bottom Panel (8) into place using Cam Lock (A) .

Set Doors (10 & 11) into place .

Hold the Support Plate (12) in the desired location of the wall unit. This plate will be about 2-1/2”
lower than the top of the wall unit. Making sure the Support Plate (12) is level, use a pencil to
mark the anchor locations using the Support Plate (12) screw holes as a guide. We recommend
using a leveler to make sure the Support Plate (12) is oriented correctly.

-Drill two 11/32” holes in these marked spots and tap the Wall Anchors (L) into the drilled holes.

Secure the Support Plate (12) to the Wall Anchors (L) with Screws (F). See Image.

-Mount the completed unit onto the Support Plate (12). The back of the unit has a recessed
area that will hook on to the Support Plate (12). Use a pencil to mark the 2nd set of anchor
locations using the holes in the wall unit as a guide. See Image.

-Remove the wall unit and drill two 11/32” holes at the pencil marks, and tap the Wall Anchors
(L)into the holes.

-Remount the wall unit and secure it to the Wall Anchors (L) with Screws (F). See image.

Insert drawer into cabinet .