Red Barrel Studio W005932822 Owner Manual

Caution : You must read this before you proceed. This headboard must be

used in conjunction with a Mattress Support Frame ( not included and not

supplied with this headboard.)

Headboard

Page 1 OF 8

Part NO. Picture Description Qty

A Headboard 1

B

Left Support Leg with 3

Mounting Brackets (With

the sticker "Left" on the

bottom)

1

C

Right Support Leg with 3
Mounting Brackets ( With
the sticker "Right" on the

bottom)

1

Label Picture Description Qty

①

Bolt M8X25mm 9

②

Spring Washer Ring 9

③

Flat Washer Ring 9

④

Nut Cap 5

⑤

Allen Key 1

⑥

Solid Wrench 1

⑦

Screws(1.6cm Self

Tapping)

2

⑧

Screws(5cm Self

Tapping)

2

⑨

Metal Brackets 4

⑩

Restraint Strap 2

⑪

Screwdriver not provide

Page 2 OF 8

Pack A: For

assembly the

legs to the

headboard

4 Bolts (①) +4Flat
Washers (③) + 4Spring
Washers (②) with the
Allen key(⑤).

Pack B: For

assembly the

legs to the

bed frame

4pcs M8X25mm
bolts(①)+ 4pcs of Flat
Washer Ring(③) + 4pcs
Spring Washer
Ring(②)+4pcs Nut
Cap(④) with a Solid
Wrench(⑥).

Overview

Unpack and
place all
parts for
clear
visibility.

Before Beginning Assembly:

Headboard(A)

Left Support Leg

with 3 Mounting
Brackets (With the
sticker "Left" on
the bottom)(B)

Right Support Leg

with 3 Mounting
Brackets (With the
sticker "Right" on

the bottom)(C)

Page 3 OF 8

To assembly the headboard to Mattress Support Frame

Put the Headboard(A) onto a flat table or panel.
With assistant to your adult partner.One person hold the headboard(A) and another
person hold the Support Leg(B)
Align the mounting position on Headboard(A) to the top and middle mounting
positions on Left Support Leg(B).

Then, lock the top and the middle mounting positions(use Pack A).
The hardware for Pack A : 4 Bolts (①) ,4Flat Washers (③) ,4Spring Washers (②)
with the Allen key(⑤).

Attach Left Support Leg(B) to the Headboard(A)using Bolts (①), Washers (③),
Spring Washers (②) with the Allen key(⑤).

Tighten to only 70% tightness.
Repeat the same steps to install the Right Support Leg(C).

At this point of assembly, DO NOT over fasten the connections.
The final height of the Headboard may be adjusted to your own need.

Note:Queen size assembly as picture (1) show;Full size assembly as picture
(2) show.

This Headboard has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Bed parts, the above picture is to
help you put the various Bed parts into perspective. Please read through the
instructions herebelow to familiarise yourself with the parts and steps before
assembly.

Step 1

A

C

B

①

③

②

⑤

Page 4 OF 8

Make sure all parts are connected and all Bolts are securely locked into position.
Your Headboard is ready for use.

Caution: This Headboard can only be used on a flat, level surface.

To assembly the headboard to your platform.
With assistant to you adult partner.
One person hold the Headboard upright and another person align the Headboard
bottom mounting positions to the Mattress Support Frame mounting positions.
Attach the Headboard to the Mattress Support Frame using Pack B.
The hardware for Pack B: 4bolts(①),4Washers(②), 4Spring Washers(③) and
4Nuts(④) with Allen Key(⑤) and Wrench(⑥).
Please install the bolts from the FRONT TO BACK of the headboard.

Step 2

Step 3

⑥

①

③

②

④

B

Mattress Support Frame

Front

Bac

⑤

Page 5 OF 8

WARNING
Serious or fatal crushing injuries can occur from tipping furniture. To help prevent
tip-over: ALWAYS secure this furniture to the wall using a Safety Restraint Device.
See product instructions for more ways to help prevent furniture tip-over.

Heardboard Restraint Device Installation Instruction

Firstly, turn back the Headboard.
Find the two marks on the product. Then,Attach Metal Brackets(⑨) to the back of
Headboard(A) using Screws(⑦) with Screwdriver(⑪) as shown above.
Make sure two parts are connected and securely locked into headboard.

⑧

⑨

⑧

⑨

B

A

C

⑦

⑨

Page 6 OF 8

Move the Headboard back against wall.
Pull the Restraint Straps(⑩) through the Metal Brackets(⑨) on the wall and
Headboard(A) one by one, and pull the Restraint Straps(⑩) tight.
Note:2pcs of Restraint Strap(⑩) on each position.
Headbaord Restraint Device is installed and Headboard is ready for use.

The strap between headboard(A) and Metal Brackets(⑨) on wall should be
within 3.5''.

Put the Headboard against the wall where desired and mark the location for the
Metal Brackets(⑨) to be the same height as the top of the Headboard.
Attach Metal Bracket(⑨) to the wall where you marked using Screws(⑧) with
Screwdriver(⑪).
Repeat this process with the other Metal Bracket(⑨).
Note: The Metal Brackets need to be secured to solid, load bearing surface. Please
use a Stud Finder(not supplied) if needed to locate the Wall Frame.

⑩

⑨

⑨

⑦

⑧

Metal Brackets on
the back side of
Headboard

Metal Brackets
on the wall

B

A

C

Page 7 OF 8

Questions & Answers about Proposition 65

• What is Proposition 65?

Proposition 65 requires businesses to provide warnings to Californians about
significant exposures to chemicals that cause cancer, birth defects or other
reproductive harm. These chemicals can be in the products that Californians
purchase, in their homes or workplaces, or that are released into the environment.
By requiring that this information be provided, Proposition 65 enables Californians
to make informed decisions about their exposures to these chemicals.
Proposition 65 also prohibits California businesses from knowingly discharging
significant amounts of listed chemicals into sources of drinking water.
Proposition 65 requires California to publish a list of chemicals known to cause
cancer, birth defects or other reproductive harm. This list, which must be updated at
least once a year, has grown to include approximately 900 chemicals since it was
first published in 1987.

• What types of chemicals are on the Proposition 65 list?

The list contains a wide range of naturally occurring and synthetic chemicals that

• What does a warning mean?

If a warning is placed on a product label or posted or distributed at a workplace, a
business, or in rental housing, the business issuing the warning is aware or
believes that it is exposing individuals to one or more listed chemicals.
By law, a warning must be given for listed chemicals unless the exposure is low
enough to pose no significant risk of cancer or is significantly below levels observed
to cause birth defects or other reproductive harm.

• Where can I get more information on Proposition 65?

If you have specific questions on the administration or implementation of
Proposition 65, you can contact OEHHA's Proposition 65 program at
[e-mail], or by phone at [phone].

Page 8 OF 8