Page 1
BEFORE YOU START:
INSTRUCTIONS:
1. Lay the top panel upside down on a flat, soft
surface such as a carpet or a cloth to prevent
scratching the top finish.
2. Attached the leg to stretcher with Allen Bolt (E),
Spring Washer (D), Flat Washer (C) tighten with
Allen wrench (F), and then insert Wood plugs (G) as
shown in Figure 1.
3. Attach the metal bridge and metal bracket to the
table top,using Bolt (A), tighten with Allen wrench
(B) as shown in Figure 2 .
4. Attached the legs to the table top with connector
Bolt (J), Plastic Washer (I) and connector nut (K),
tighten with Allen wrench (F) as shown in Figure 3.
5. Last assemble "U" Hardware to legs, using Bolt (H),
Spring Washer (M), Flat Washer (L), tighten with
Allen wrench (B) as shown in Figure 4. (Note:
Don't tighten all the bolts. Align the pin with
hole of the swivel arm and make sure the pin
can move through the hole easily.)
6. To adjust the angle of the desk surface, then pull
and turn both sides pin handles to lock the pin from
position 1 to position 2. As shown in Figure 5.
Adjust the desk surface and unlock the pins
aligning them with one of the holes in the swivel
arm.
Thank you for purchasing furniture!
Loading...