Page 1
Label Picture Description QTY
A Chair Back 1
B Chair Base 1
Caution : You must read this before you proceed
Club Chair
Page 1 OF 6
Page 2
C Front Leg 2
D Back Leg 2
Label Picture Description QTY
① Gasket 7
Page 2 OF 6
Page 3
Step 1
This Club Chair has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Club Chair parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the parts and
steps before assembly.
Place the Chair on its back on a clean, non-marring surface as pictured above.
Carefully unzip the pouch at the bottom of the Chair Base(B) and remove the Front Leg(C), Back
Leg(D) and Hardware.
Close the pouch.
Chair Back (A)
Front Leg (C)
FRONT FACING
Chair Base (B)
Chair Base (B)
Page 3 OF 6
Page 4
Step 2
Step 3
Position yourself behind the Chair and place the Chair Back(A) into the Chair Base(B).
Tilt the Chair Back slightly forward, then gently pull the Chair Back towards you while pushing it
down all the way into the Chair Base.
If you find a gap between the Chair Back(A) and Chair Base(B), please push rock the Chair
Back(A) back and forth slightly, while pressing the Chair Back downwards until the gap
disappeares.
Chair Back(A)
Chair Base(B)
Chair Base (B)
Chair Back (A)
Chair Back(A)
Chair Base(B)
Page 4 OF 6
Page 5
Step 4
Step 5
Your Club Chair is ready for use.
This Club Chair can only be used on a flat, level surface.
Install Front Leg(C) into the Chair Base(B) by putting a Gasket(①) on the threaded stem.
Then insert the threaded stem into the mounting position at the corner of the bottom of Chair
Base(B).
Tighten by turning the Front Leg(C) clockwise by hand.
Repeat the same process to install the remaining Front Leg(C) and Back Leg(D).
The use of Gaskets are OPTIONAL and are especially useful to help alleviate slight
wobbles.
Front Leg(C)
Back Leg(D)
Back Leg(D)
Gasket(①)
Front Leg(C)
Page 5 OF 6
Page 6
Page 6 OF 6
Loading...