Page 1
INSTALLATION INSTRUCTIONS
NOTE: Finial shown is for illustration purposes only.
It may not represent the style of finial purchased.
STEP 1:
ROD SETS
Place brackets against wall at desired locations.
Mark screw holes with pencil. Be sure marks are
level across opening.
STEP 2:
If screws are going directly into wood trim or wall studs, drill a 1/8" pilot
hole at pencil marks. If screwing into drywall, follow instructions on
enclosed sheet.
STEP 3:
Assemble rod and slide drapery treatment
onto rod.
Drapery
STEP 4:
Screw finials onto rod. Rotate finial on rod for proper
alignment if required.
STEP 5:
Extend rod to desired width. Lift rod with drapery
and drop into brackets. Adjust draperies to
desired position.
STEP 6:
Lock rods into position by tightening leveling
screw by hand until finger tight. This will prevent
the rod from moving.
Loading...