Page 1
Caution : You must read this before you proceed
Recliner Chair
Page 1 OF 10
Page 2
Label Picture Description QTY
A Chair Backrest 1
B1 Right Wing 1
B2 Left Wing 1
C Chair Base 1
D Front Leg 2
E1 Right Back Leg 1
E2 Left Back Leg 1
Label Picture Description QTY
①
②
③
④
Plastic Washer (M8）
Flat Washer（M6)
Bolt(M6*40mm) 3
Allen Key（M6)
3
3
1
Page 2 OF 10
Page 3
⑤
Bolt(M8*40mm) 7
⑥
⑦
⑧
Before
Beginnin
g
Assembly
:
Allen Key（M8)
Flat Washer （M8)
Spring Washer (M8）
1
7
7
M6
M8
Left Wing(B2)
FRONT FACING
Chair Backrest(A)
Right Wing(B1)
Chair Base(C)
Back Leg(E)
Front Leg(D)
Page 3 OF 10
Page 4
This Recliner Chair has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Recliner Chair parts, the above
picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and
steps before assembly.
Step 1
Chair Base(C)
Place the Chair Base(C) on a chean non-marring surface.
Lay Chair Backrest(A) and inner box aside.
Open the inner box and take out the Four Legs and Hardwares.
Step 2
Inner Box
Chair Base(C)
B2
Turn the Chair Base(C) upside down on a clean, non-marring surface.
Extend the Footrest to Open.
Carefully take out Inner Box stowed as show n above.
Open it,and You will find Wings(B1)&(B2).
B1
Stow the Footrest to Original Position.
Page 4 OF 10
Page 5
Step 3
Front Leg(D)
Chair Base(C)
Front Leg(D)
Keep the Chair Base(C) in the same position, first .install the Front Leg(D)
at the bottom of the Chair by placing one Plastic Washer① on the threaded
stem,Then insert threaded stem into the threaded mounting position at the
corner of the chair.
Tighten by turning the Leg Clockwise,DO NOT OVER TIGHT
Repeat the same step to install the remaining another Front Legs(D).
Take care of the shape of the Legs and ensure they are in the correct
positon.
Note:The use of the Gaskets are OPTIONAL and are especially useful
to help alleviate slight wobbleness.Some legs may need more than
one gasket whilst some legs may not need any.
Step 4
Left Back Leg(E2)
Right
Back
Leg(E1
)
⑧
Front Leg(D)
Chair Base(C)
Front Leg(D)
Position the Chair Base(C) on its back, as shown.
Attach the Right Black Leg(E1) to Chair Base(C) using Bolt (
⑤),Washer
(⑦)and Spring Washer(⑧) with Allen Key(⑥).
Repeat the same steps to install the remaining Left Black
Leg(E2),as shown above.
Page 5 OF 10
Page 6
Step 5
B1
B2
A
Position the Chair Backrest(A) on it's right side.
Align the mounting positions of the Right Wing(B1) to the right side of Chair
Backrest(A) and Repeat the same step to install the Left Wing(B2) to the
left side of Chair Backrest(A) as shown above.
Step 6
B1
②
③
④
A
B2
Attach Left Wing(B2) and Right Wing(B1)to the Chair Backrest(A) using
Bolts(③) and Flat Washer(②) with Allen Key(④).
Fully tighten it until secure.
Step 7
A
C
Page 6 OF 10
Page 7
With assistance from your adult partner,hold up the fully assembled
backrest with Wings,stand behind the chair.Insert the small metal arms on
the sides of the Chair Backrest(A) into the prefabricated slide lock gadget
on the Chair Base(C) as shown above.
Firmly but gently, push the Chair Backrest(A) dow nwards until the Backrest
is fully slotted and locked into position.
Step 8
Smooth down the fabric flap one the Chair Backrest
Run your hands down both sides of the flap,from top to bottom,allowing the
velcro tape to adhere to the flap under the seat of the chair.
Step 9
Make sure parts are connected and securely locked into position.
Your Chair is ready for use.
Page 7 OF 10
Page 8
Step 10
A
A
B1
B2
E 2
E 1
C
D
C
Disassembly Note:Open the flap on the Chair Backrest(A),use a
screwdriver(Don't use fingers)pressing outward on the metal ear on the
preattached Metal Bracket on one side of the Chair Base(C),with
assistance of your adult partner to keep the Chair Base(C) in place,pull out
the Chair Backrest(A) upward at the same time,repeat the same step for
another side.Then the Chair Backrest(A) can be taken out.
Page 8 OF 10
Page 9
User Instructions.
Recliner Chair
Please read the Instruction Manual below carefully before use.
This is a Recliner Chair. At anytime in a reclined seat position or in the
upright position. You may enjoy the rocking motion by using your body
weight in a back-front rocking motion.
Supervise children, when in use of this Recliner.
Do not let children stand in front of or behind the Push Back Chair when
opening or closing the footrest.Do not put your hands inside the Footrest
when opening or closing the footrest.Do not sit any armrest of this Push
Back Chair.
To get into a reclined posture - To Recline backrest
Sit into the seat.
Place your feet apart .
Place your left and right arm onto the armrest.
Synchronise a backward push with your arms.
Use your body weight and push backwards into the seat into a fully reclined
position.
To get out of chair - move Seatback into Upright Position
Tilt your body weight slightly forward and upw ards.
The seat back will come up to an upright position.
Where necessary, use either your arms help lift- push yourself out of the
seat.
Page 9 OF 10
Page 10
Page 10 OF 10
Loading...