Page 1
Student Desk
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
PART LIST
A.
Top Unit
1 pc.
B.
Side Frame
1 pc.
C.
Side Frame
1 pc.
D.
Stretcher
1 pc.
HARDWARE LIST
Key Wrench
1 pc.
Spring Washer
8 pcs. (+1 extra )
Flat Washer
8 pcs. (+1 extra )
Tools required for assembly : Phillips screwdriver Tools recommended for assembly : Level
Bolt
8 pcs. (+1 extra )
Wood Screw
2 pcs. (+1 extra)
Page 2
Assembly Instructions
IMPORTANT
* Use a soft cloth between these parts and the floor.
* Do not tighten up all the screws until each part is properly assembled.
* You should keep Key Wrench in a safe place as you may need to tighten up the Bolts in the future.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
STEP 1
Turn the Top (A) upside down
and place it on a soft cloth.
Remove all the drawers.
Wood Screw
C
F
Flat Washer
Spring Washer
Bolt
D
A
STEP 2
Attach Side Frame (B) and (C)
to Top (A) with Flat Washers,
Spring Washers and Bolts.
Tighten only half way. (See figure 1)
Attach Stretcher (D) to the unit
with Wood Screws.
Tighten all bolts.
Flat Washer
Spring Washer
A
STEP 3
Turn the unit over to its’ upright position.
Remove the Pull Handles that are installed
on the inside of the drawers and re-install
them on the outside of the drawer.
(See figure 2)
Slide the drawers into position
(Figure 2)
STEP 4
.
B
Key Wrench
Bolt
(Figure 1)
To level the unit, adjust the adjustable
levelers on the bottom of unit. (See figure 3)
(Figure 3)
Loading...