Page 1
Assembly Instructions
Keep your child / children at bay in the process of
Caution : You must read this before you proceed.
BAR STOOL
CAUTION : This PRODUCT is NOT a TOY.
assembly.
Page 1 of 6
Page 2
Assembly Preparation
Parts List
Before Beginning Assembly:
NO. Picture QTY
A 1
B 1
C 1
D 1
E 2
F 2
Seat
Right Leg Panel
Left Leg Panel
Backrest Bar
Seat Support Bar
Leg Support Rail
Description
Hard ware
G 15
H 1
Screws (M6x60mm)
Allen Key
Page 2 of 6
Page 3
Assembly Step
Then repeat the same process for the Left Leg Panel(C).
Unpack and place all parts on a clean, non-marring surface.
Place the Right Leg Panel(B) face up on its side.
Align and insert Backrest Bar(D), Seat Support Bars(E) and Leg Support
Rails(F) with tenons from the bars sitting snugly into Mortises on Right Leg
Panel(B).
Insert the Screws(G) through Mounting Positions on the Right Leg
Panel(B) with Allen Key(H).
Page 3 of 6
Page 4
Step 3
align the Mounting Position of the Stool Frame to the Mounting Positions at
Stand the Stool Frame up and place Seat(A) onto the Stool Frame.
To affix the Seat to the Stool Frame, carefully lay down the Bar Stool and
the Seat(A).
Insert Screws(G) through the Mounting Positions with Allen Key(H) and
slightly tighten the Screws.
Then stand the Bar Stool up. Check both sides of Seat(A) are flush with
the Stool Frame and tighten the Screws(G) sequentially.
If no wobbles found, proceed to tighten all the screws.
CAUTION : When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the Stool Frame to warp.
If there is still wobbles, loosen the screws and execute this same drop
tests.
WARNING!! IF CHAIR IS NOT STABLE , IT COULD LEAD TO
DAMAGING THE PRODUCT.
Page 4 of 6
Page 5
Step 4
If wobble
Test again
30CM~50CM
Place the chair on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the chair to some 30cm to 50cm height from the ground.
Keep your feet and toes well away from the drop zone.
Drop the chair freely and vertically with the four legs, hitting the ground, at
the same time.
This Drop Test will help to ensure that all the screws and gaps to all reach
full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles found, proceed to tighten all the screws.
CAUTION: When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the screws and execute this same drop
tests.
Step 5
Ensure that all Screws are securely tightened.
Your Bar Stool is ready for use.
Page 5 of 6
Page 6
Page 6 of 6
Loading...