Page 1
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Plate (A)
Headless Screw(D)
Mounting Screw (B)
Outlet Box
Green Grounding Screw (C)
House Grounding Wire
Fixture Grounding Wire
Mounting Plate (A)
Mounting Screw (B)
Lock Nut(G)
Green Grounding
Screw (C)
Wire Nut (E)
Headless Screw(D)
Back Plate
Fixture Wire
Wire Nut (E)
Ball Nut (F)
Ball Nut (F) Lock Nut (G)
Glass Bracket
Socket
Socket Ring
Glass Shade
Bulb Type A Max.100W
(not included)
Installation Steps
Turn off the power at fuse or circuit box.
1. Thread two headless screws through the mounting plate, then secure them with four lock nuts (two on each side of the
mounting plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be level.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green grounding
screw. Then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate by inserting two headless screws, then secure
it with two ball nuts.
T
Page 2
5. Attach the glass shades to the glass brackets, secure them with socket rings.
6. Install bulbs(not included). See relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Plate (A)
headless Screw(D)
Mounting Screw (B)
Wire Nut (E)
Green Grounding
Screw (C)
Ball Nut (F)
Assembly Kit
(1 SET)
Lock Nut (G)
A: 23-1/2"
B: 9"
C: 8-1/4"
Loading...