Page 1
Caution :You must read this before you proceed
CHAIR
1 of 6
Page 2
Label Picture Description QTY
A Chair Base 1
B Front Leg 2
C Back Leg 2
Label Picture Description QTY
①
Before Beginning Assembly:
Washer Ring 7
2 of 6
Page 3
Chair Base (A)
Front Leg (B)
Front Leg (B)
Back Leg (C)
FRONT FACING
This CHAIR has multiple parts and may require up to some 30minutes to
assemble. To give you an overview of the CHAIR parts, the above
picture is to help you put the various parts intoperspective. Please read
through the instructions below to familiariseyourself with the parts and
steps before assembly.
Step 1
Chair Base (A)
Position the Chair Base (A) on its back,as shown.
Unzip to open pouch and remove the 4 wooden legs and hardwares, close
the pouch.
3 of 6
Page 4
Step 2
Back Leg (C)
Front Leg (B)
Install the Leg(B&C) into the bottom of the Chair Base (A) by placing the
Washer Ring (①) onto the threaded stem.
And then insert the threaded Stem into the threaded Mounting Position at
each Corner of the Bottom of the Chair.
Tighten by turning the Legs clockwise.
Repeat the same steps to install the three remaining legs.
Chair Base (A)
Washer Rings(①)
Note:The use of Washer Rings are OPTIONAL and is especially useful to
help alleviate slight wobbleness.Some legs may need more than one
Washer Rings(①) whilst some legs may not need any.
Step 3
4 of 6
Page 5
Place the chair on a LEVEL SURFACE to see if it wobbles.
If it wobbles, press firmly down on both armrests at the same time. This
will help to ensure all Bolts and gaps reach full alignment status.
If no wobbles found, proceed to tighten all the Bolts. DO NOT fully tighten
a BOLT in one go and then move on to the next. Rather, in a sequential
manner, gradually tighten each Bolt until all Bolts are evenly secured.
This methodology will ensure maximum eveness once all Bolts are fully
tightened.
Step 4
Your CHAIR is ready for use.
Your CHAIR can only be used on a flat, level surface.
5 of 6
Page 6
6 of 6
Loading...