Page 1
9LT PENDANT LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
ASSEMBLY AND INSTALLATION
(CONT.)
CAUTION
installation.
shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
referencing the illustrations on the installation instructions.
TOOLS REQUIRED
Phillips screwdriver , pliers.
ASSEMBLY AND INSTALLATION
Turn off the power at fuse or circuit breaker.
1. Attach the NIPPLE to the CROSS BAR, then secure it with a WASHER and HEX NUT.
2. Attach the CROSS BAR to the JUNCTION BOX by using two JUNCTION BOX SCREWS.
3. Secure the TOP LOOP to the NIPPLE.
4. Adjust ARMS to proper position.Secure the FIXTURE A to the FIXTURE B.
5. Choose the length of the CHAIN you need, then weave the FIXTURE WIRE and the FIXTURE GROUND
WIRE through the CHAIN, COLLAR and CEILING PLATE.
6. Open the top and bottom section of the CHAIN using a phillips screwdriver (not included) and pliers
(not included), then attach it to the LOOP. Close the CHAIN.
7. Thread the FIXTURE WIRE and FIXTURE GROUND WIRE through the TOP LOOP, NIPPLE and
CROSS BAR.
8. Pull out the SUPPLY WIRES and SUPPLY GROUND WIRE from the OUTLET BOX. Make wire
connections using the WIRE CONNECTORS:
A
B
---Attach the FIXTURE GROUND WIRE to the CROSS BAR with the GREEN GROUND SCREW.
C
Then connect it to the SUPPLY GROUND WIRE with a WIRE CONNECTOR.
Carefully put the wires back into the OUTLET BOX.
9. Attach the CEILING PLATE to the CROSS BAR by inserting the TOP LOOP, then secure it with the COLLAR.
10. Screw the DECORATIVE NUT onto the FIXTURE B.Attach the GLASS onto FIXTURE B using SOCKET
RINGS.
11.Install BULB (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit breaker.
C
A
B
3
2
1
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
Loading...