Page 1
Tighten the screws clockwise with hex key.
Desk legs can adjust 1-2cm
length, keep the desk stable
even on uneven floor.
The trick to make this table more sturdy:
Step 1: Place the top upside down on the floor and screw in the bolts until they both have
some resistance.
Step 2: Tighten them a little bit at a time alternating bolts. Once both the bolts are tight hold
the end of the leg and push and pull it back and forth. You will find the bolts are now loose.
Step 3:Tighten the bolts again as before and repeat to get to the point where pushing and Step 3:Tighten the bolts again as before and repeat to get to the point where pushing and
pulling the leg no longer loosened the bolts. At that point the leg was very solidly attached.
Loading...