Page 1
Assembly Instructions
Caution: You must read this before you proceed
Please look in the iron leg for hardware packs.
Bench
Caution: This Bench is NOT a TOY.
Keep your child/children at bay during the assembly process.
Whenever moving/lifting the Bench and to prevent damage to the Bench,
two adults are required to execute these actions.
Page 1 of 6
Page 2
Label Picture Description QTY
A Seat Panel 1
B Iron Leg 2
C Support Bar 1
Label Picture Description QTY
①
Bolt (M8x20mm) 13
②
Washer (8.5/20x2mm) 13
③
Allen Key 1
Part List
Hardware
Page 2 of 6
Page 3
Before Beginning Assembly:
This Bench has multiple parts and may require up to 15 minutes to assemble. To give
you an overview of the Bench parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions below to familiarise yourself
with the parts and steps before assembly.
Assembly Preparation
Assembly Steps
Overview
Seat Panel (A)
FRONT FACING
Support Bar(C)
Iron Leg (B)
Page 3 of 6
Page 4
Step 1
Step 2
Place the Seat Panel(A) facedown onto a clean, non-marring surface.
Attach Iron Legs(B) to Seat Panel(A) using Bolts(①) and Washers(②) with Allen
Key(③).
Note: The mounting positions on the Legs should face inside.
Do not fully tighten the Bolts.
Unpack and place all parts on a clean, non-marring surface.
B
3
2
1
A
Page 4 of 6
Page 5
Step 3
Step 4
Attach Support Bar(C) to Iron Legs(B) using Bolts(①), and Washers(②) with Allen
Key(③) as pictured above.
Do not fully tighten the Bolts.
Stand the Bench right side up.
Place the Bench on a LEVEL surface.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit onto the Bench.
This pressure will help the Legs and Bench reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly
secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolts fully and then move on towards the next one.
Your Bench is ready for use.
This Bench can only be used on a flat, level surface.
3
1
2
B
C
B
Page 5 of 6
Page 6
Page 6 of 6
Loading...