Page 1
Assembly Instructions
Caution: You must read this before you proceed
CHAIR
Caution: This Chair is NOT a TOY
Keep your child/ children at bay during the assembly process.
Whenever moving/lifting the Chair and to prevent damage to the Chair two adults are
needed to execute these actions.
1 ____
Page 2
Label Picture Description QTY
A Backrest Panel 1
B Seat Panel 1
C Leg Panel 2
D Seat Cushion 1
Label Picture Description QTY
① Bolt (M6x65mm) 5
② Bolt (M6x35mm) 3
③ Spring Washer (M8.5x2mm) 11
④ Washer (M8.5x2mm) 11
⑤ Nut (Ø8x6mm) 5
⑥ Allen Key 1
⑦ Spanner 1
Hardware
Parts List
2 ____
Page 3
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of
the Chair parts, the above picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and steps before assembly.
Assembly Preparation
Assembly Steps
Overview
Before Beginning Assembly:
Seat Panel (B)
Backrest Panel (A)
FRONT FACING
Leg Panel (C)
Seat Cushion (D)
3 ____
Page 4
Step 1
Place the Backrest Panel(A) facedown onto a clean, non-marring surface.
Align Seat Panel(B) to Backrest Panel(A) then attach using Bolts(②), Spring Washers(③), and
Washers(④) with Allen Key(⑥).
Do not fully tighten the Bolts.
Unpack and place all parts on a clean, non-marring surface.
Step 2
4 ____
Page 5
Attach Seat Panel(B) to Backrest Panel(A) using Bolts(①), Spring Washers(③), and Washers(④) with
Allen Key(⑥).
Do not fully tighten the Bolts.
Step 3
Step 4
Attach Leg Panel(C) to Seat Panel(B) using Nuts(⑤), Spring Washers(③), and Washers(④) with
Spanner(⑦).
Do not fully tighten the Bolts.
Repeat the same process with the remaining Leg Panel(C).
5 ____
Page 6
Place the Chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit into to the Chair.
This will help to align all the parts at all joint areas.
Then get off the Club Chair and proceed to tighten the Bolts in a sequential manner.
When tightening the Bolts tighten sequentially.
DO NOT tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and execute this same process.
Step 5
6 ____
Page 7
Step 6
Place Seat Cushion(D) into the Chair.
Attach the velcro of Seat Cushion(D) to the Chair as shown above.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
7 ____
Page 8
8 ____
Loading...