Page 1
ASSEMBLY INSTRUCTIONS
Description
- 1 -
: LEANING SHELF
Printed in Vietnam
Page 2
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call us.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
product. Protect the surface of the product with cloth if you are using any product with rubber feet or
base.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED
- 2 -
Printed in Vietnam
Page 3
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
Upper Post
A
(Left-Right)
Top shelf
C
(the smallest)
E 3rd shelf 1
Bottom shelf
G
(the biggest)
2
1
1
Lower Post
B
(Left-Right)
D 2
F 4
nd
shelf 1
th
shelf 1
2
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
3
5
7
9
Short Bolt
(M6 x 25mm)
Allen Key
(4x80 mm)
Short Screw
(M3 x 15mm)
Plastic Dowel
(M5 x 30mm)
Long Bolt
(M6 x 40mm)
20
1
4
2
4
- 3 -
Flat Washer
2
(6.5 x 13mm)
Steel Band
4
(1.2x15x100mm)
Long Screw
6
(M4 x 30mm)
Wood Plug
8
(14.5mm)
24
2
2
20
Printed in Vietnam
Page 4
STEP 1
Carefully attach posts (A) and (B) together with bolts (9), and washers (2) as shown below. Tighten
with Allen Key (3).
B
STEP 2
Carefully place the 5 shelves (C), (D), (E), (F), (G) between the 2 Side posts, Attach the shelves to the
posts with bolts (1) and washers (2) as shown below. Tighten with Allen key (3).
G
B
- 4 -
Printed in Vietnam
Page 5
STEP 3
Attach the steel bands (4) with screws (5) at position as shown below.
DO NOT FULLY TIGHTEN all screws and bolts until the product is leaning against the wall.
STEP 4
Insert the Plastic dowels (7) into the wall. Attach the unit to the wall with screws (6) to secure the
product and prevent tipping as shown below.
Then, put the Wood Plugs (8) over screws to cover them.
7
6
- 5 -
Printed in Vietnam
Loading...