Page 1
CHAIR
CAUTION: This Chair is NOT a TOY. Keep your child / children at bay in the process
of assembly. For turning the Chair and to prevent damage to the Chair, 02 persons
may be needed to execute this action.
CAUTION: You must read this before you proceed
1 of 7
Page 2
Label Picture Description Qty
A
Backrest Panel 1
B
Seat Panel 1
C
Left Leg Panel 1
D
Right Leg Panel 1
E
Seat Cushion
1
No. Picture Description Qty
① Allen Key 2
② Screw (M6*35mm) 3
③ Screw (M7*70mm) 7
2 of 7
Page 3
Before Beginning Assembly:
This Chair has multiple parts and may require up to some 30 minutes to
assemble. To give you an overview of the Chair the above picture to
assemble to help you put the various parts into perspective. Please read
through the instructions here below to familiarise the parts and steps before
assembly.
OVERVIEW
Backrest
Panel (A)
Left Leg
Panel (C)
Right Leg
Panel (D)
Seat Cushion
(E)
Seat Panel (B)
FRONT FACING
3 of 7
Page 4
Attach Left Leg Panel (C) to Backrest Panel (A) and Seat Panel (B) using 3
Screws (③) + Allen Key (①).
Do not fully tighten the Screws.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
Do not fully tighten the Screws.
Step 3
2.1
2.2
4 of 7
2.1) Position Seat Panel (B) to Backrest Panel (A) as shown in the above
picture.
2.2) Secure Seat Panel (B) with Backrest Panel (A) using 2 Screws (②) +
Allen Key (①)
Page 5
With assistance from your adult partners, turn the Chair into the other side.
Repeat the same process of step 3 to secure Right Leg Panel (D) with
Backrest Panel (A) and Seat Panel (B).
Do not fully tighten the Screws.
Step 4
Step 5
Stand the Chair up, with assistance from your adult partner.
Exert pressure floorwards, onto the Chair with both your hands.
This pressure will help the Legs and Chair reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten Screws in a sequential manner,
until evenly secured.
When tightening Screws tighten sequentially.
Do not tighten any Screw fully and then move on towards the next one.
If there are still wobbles, loosen Screws and excute the same above
process.
5 of 7
Page 6
Step 6
Place Seat Cushion (E) on to the Chair and tie the velcro straps of Seat
Cushion (E) to Backrest Panel (A) as shown above.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
6 of 7
Page 7
7 of 7
Loading...