Red Barrel Studio W000908941 Assembly Instructions

Assembly Instructions
Caution: You must read this before you proceed
Table
Caution: This Table is NOT a TOY. Keep your child / children at bay during the assembly process. Whenever lifting or moving the Table and to prevent damage to the Table, two adults may be needed to execute these actions.
Label Picture Description QTY
A
Table with Foldable
Legs
1
Label Picture Description QTY
Bolt (M8x60mm) 5
Bolt (M8x45mm) 11
Allen Key 1
Parts List
Hardware
Assembly Preparation
Before Beginning Assembly:
Step 1
Overview
This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise youself with the parts and steps before assembly.
Unpack and place all parts on a clean, non-marring surface.
Assembly Steps
FRONT FACING
Table with
Foldable Legs (A)
Leg
Step 2
Step 3
Place the Table with Foldable Legs(A) facedown, onto a clean, non-marring surface. Fold out the Legs until the braces are flush with the base of the Table with Foldable Legs(A), as shown in the above picture.
3.1) Secure Legs using Bolts() with Allen Key() as pictured above.
3.2) Secure Legs using Bolts() with Allen Key() as shown above. Do not fully tighten the Bolts.
Step 4
Step 5
Secure Legs using Bolts() with Allen Key() as pictured above.
Do not fully tighten the Bolts.
Stand the Table up, with assistance from your adult partner. Exert pressure floorwards, onto the Table with both your hands. This pressure will help the Legs and Table Top reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured.
When tightening the Bolts tighten sequentially. Do not tighten any Bolt fully and then move on towards the next one. If there are still wobbles, loosen the Bolts and excute the same above process.
Your Table is ready for use.
This Table can only be used on the flat, level surface.
Loading...