Page 1
Caution: This Bar Chair is NOT a TOY.
Keep your child / children at bay during the assembly process.
For moving the Bar Chair and to prevent damage to the Bar Chair, two
adults are needed to execute this action.
Page 2
Page 3
This Bar Chair has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Bar Chair parts, the above
picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and
steps before assembly.
Page 4
Unpack and place all parts on a clean, non-marring surface.
2.1) Insert Wooden Dowel on Backrest Panel(A) into Right Leg Panel(G)
then attach using Screw( ) with Allen Key( ) as above picture.
2.2) Insert the tenons on Seat Support Bar(C) and Back Footrest(D) into
the mortises of Right Leg Panel(G) as shown above.
Attach Right Leg Panel(G) to Seat Support Bar(C) and Back Footrest(D)
using Screws( ) with Allen Key( ) as shown in picture above.
Do not fully tighten the Screws.
Page 5
3.1) Attach Seat Support Bar(C) to Right Leg Panel(G) using Screw( )
with Allen Key( ).
3.2) Attach Front Footrest(E) to Right Leg Panel(G) using Screw( ) with
Allen Key( ).
Do not fully tighten the Screws
With assistance from your adult partner, turn the Bar Chair over onto
another side.
Attach Left Leg Panel(F) to Backrest Panel(A), Seat Support Bars(C),
Back Footrest(D), and Front Footrest(E) using Screw(①), Screw(②)
and with Allen Key(④)
Do not fully tighten the Screws.
Page 6
With assistance from your adult partner, put Seat Panel(B) to Bar Chair as
pictured. Attach Seat Panel(B) using Screws(③) with Allen Key(④).
Do not fully tighten the Screws.
Stand the Bar Chair up, with assistance from your adult partner.
Exert pressure floorwards, onto the Bar Chair with both your hands.
This pressure will help all Bar Chair parts and Screws reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Screws in a sequential manner, until
evenly secured.
When tightening the Screws tighten sequentially.
Do not tighten any Screw fully and then move on towards the next one.
If there are still wobbles, loosen the Screws and excute the same above process.
Your Bar Chair is ready for use.
This Bar Chair can only be used on the flat, level surface.
Page 7
Loading...