Page 1
(B1 & B2)
EASTERN KING SIZE BED
ASSEMBLY INSTRUCTIONS
PAGE 1 OF 4
Page 2
1
4
2
5
3
PARTS IDENTIFICATION
HARDWARE IDENTIFICATION
*FROM BOX 1
*FROM BOX 1
(B1 & B2)
ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2. This product is for home use only and not intended for commercial establishment.
B1 (BOX 1)
A
B
C
D
E
HEADBOARD PANEL
RIGHT HEADBOARD LEG
LEFT HEADBOARD LEG
FOOTBOARD
BED SLAT
1PC
1PC
1PC
1PC
4PCS
F
B2 (BOX 2)
G
HB
D
BED SLAT SUPPORT
WITH LEVELER
BED RAIL
HEADBOARD
COMPLETE
FOOTBOARD
8PCS
2PCS
1PC
1PC
Z - B1 (BOX 1) - Hardware pack is located in (B1)
BOLT 6PCS
LOCK WASHER 6PCS
FLAT WASHER 6PCS
ALLEN WRENCH 1PC
SCREW 8PCS
PAGE 2 OF 4
Page 3
**BACK VIEW
**BACK VIEW
leg as shown on the drawing.
(B1 & B2)
(B1) - BOX 1
STEP 1 STEP 2
Place headboard panel face downward on a soft surface.
Then attach the left and right headboard legs to the
headboard panel. Note: follow the sticker label on the
A
C
STICKER 'L'
B
STICKER 'R'
Align and fasten left & right headboard leg to
headboard panel using bolt,lock washer & flat washer
and tighten with Allen wrench.
ASSEMBLY INSTRUCTIONS
4
2
1
3
A
C
( B1 & B2 ) - BOX 1 & BOX 2
STEP 3
3.1) Align and hook bed rails to headboard leg and footboard.
3.2) Tap in the bed rails with a rubber mallet ( NOT INCLUDED ).
3.1
C
HB
B
3.1
G
G
3.2
D
G
PAGE 3 OF 4
Page 4
STEP 5
STEP 6
tighten with screw driver (NOT INCLUDED).
(B1 & B2)
STEP 4
Screw in bed slat support with leveler to bed slat.
ASSEMBLY INSTRUCTIONS
Align and fasten bed slats to bed rails using screw and
Adjust leveler to touch the floor.
HB
5
G
F
D
E
Complete
PAGE 4 OF 4
Loading...