Page 1
ASSEMBLING
&
Ceiling
For
Ceiling
Ceiling Mount
INSTRUCTIONS
Mount
Mount
Lighting
Lighting
Lighting Fixtures
Fixtures
Fixtures
INSTALLATION
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING
MOUNTING
MOUNTING
MOUNTING THE
1. Shut off the power at the fuse box or circuit breaker box.
Remove the old fixture from ceiling, including the single
bar .
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread end of nipple ( C ) into single bar (D) until snug.Place
lock washer (B) over end of nipple protruding through
single bar and thread hex nut (A) onto nipple until tight.
4. Take this single bar assembly and mount to ceiling junction
box with junction box screws (E). Tighten screws securely
with screwdriver.The side of the single bar marked "GND"
must face out.
5. Hold the pan ( F ) towards the single bar and connect the
electrical wires as follows (See Fig.2). Connect the black
wire from the fixture to the black house (hot) wire; connect
the white wire from the fixture to the white house ( neutral)
wire. Make sure all wire nuts are secured.
the connections with electrical tape. If your outlet box has
a ground wire (green or bare copper) connects fixture’s
ground wire to it. Other wise attach the bare copper fixture
wire to the green ground screw on the single bar. Tuck the
wire connections neatly into the ceiling junction box as you
are holding the fixture assembly toward the ceiling.
6. Raise p an ( F ) to the junction box, aligning nipple on
single bar with center hole in the p an and lock it securely
with the knurled nut ( G ).
7.
7.
7.
7. Install the light bulbs in accordance with the fixture
specifications. DO
WATTAGE
WATTAGE
WATTAGE
WATTAGE
8. Put the glass shade ( H ) in to the frame ( I ) , Raise the
assembly to the pan(F), aligning small nipple on the pan
with small hole in the frame(I), lock it with the ball nut(J).
THE
FIXTURE
THE
FIXTURE
THE FIXTURE
FIXTURE
DO
NOT
DO
NOT
DO NOT
NOT EXCEED
RATING!
RATING!
RATING!
RATING!
EXCEED
EXCEED
EXCEED THE
THE
THE
THE MAXIMUM
You
may wrap
MAXIMUM
MAXIMUM
MAXIMUM
Fig.1
Fig.1
Fig.1
Fig.1
H
’
s
J
I
Your
Your
Your
Your
junction
junction
junction
junction box
Fig.2
Fig.2
Fig.2
Fig.2
FIXTURE
WIRES
Black or
Smooth
installation
installation
installation
installation is
box
and
box
and
box and
and test
FIXTURE
WIRES
White or
HOUSE
WIRES
Black
(Hot)
Ribbed
is
now
is
is now
test
test
test the
complete.
now
complete.
now complete.
complete. Return
the
fixture.
the
fixture.
the fixture.
fixture.
HOUSE
WIRES
White
(Neutral)
Return
Return
Return power
FIXTURE
WIRES
Bare
Copper
(Ground)
Bare Copper(Ground)
power
power
power to
HOUSE
WIRES
Green or
to
to
to the
the
the
the
MIN
90
MIN
90
MIN
MIN 90
90
℃ SUPPLY CONDUCTORS
U
L
R
Listed
Loading...