Red Barrel Studio DBHM1216 Installation & Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT

OUTDOOR POST MOUNT LIGHT FIXTURE

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

ASSEMBLING THE FIXTURE (Fig.1).

1. Carefully unpack new fixture and lay all the parts on a

clear surface.Take care not to lose any small parts
necessary for installation.

2. NOTE: Discharge of the loop(A), take out cover(B),(C)

and glass shade(D).

3. Install the light bulbs(no included) in accordance with

the fixture’s specifications. DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!

4. Attach the glass shade(D) to the lamp body(E) ,aligning
the top center hole with the pipe screw, attach the
cover(C) and (B) to the glass shade(D), then lock it
securely with the loop(A).

5. Attach the assembly lamp body onto the post(E, no
included) and lock it securely with the screw (F).

Wiring (Fig.2)

1. Connect the electrical wires as follows. Connect the

black wire from the fixture to the black house (hot)
wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape. If your outlet box has a ground wire (green or
bare copper) connect fixture’s ground wire to it.
Otherwise attach the bare copper fixture wire to the
green ground screw on the circular strap.

2. Tuck the wire connections neatly into the junction

box.

Your installation is now complete. Return power to the
junction box and test the fixture.

Fig.2

Fig.1

A

Fixture
Ground Wire

FIXTURE
WIRES

Black or
Smooth

HOUSE
WIRES
Black

(Hot)

FIXTURE
WIRES
White or
Ribbed

HOUSE
WIRES
White

(Neutral)

FIXTURE
WIRES
Bare
Copper

(Ground)

HOUSE
WIRES
Green or

Bare Copper(Ground)