The benchmark in heavy vehicle safety.
REDARC has over 40 years’ experience in the design and manufacture
of high quality, reliable, Australian-made products for heavy vehicle applications.
Battery Master Isolation Switch
The REDARC Battery Master Isolation Switch (BMIS) is designed
to safely isolate the vehicle batteries in both 12 and 24 volt vehicles
ensuring reliable performance when the vehicle is operating.
It allows for manual isolation of a truck’s electrical system from its
battery. It will work with existing roll over sensors on the market.
Features:
• In-built lockout capability
• Increased reliability with dual
redundancy to avoid falsetriggering
• Easy to install as new or a retrofit
• Compatible with roll over sensors
• Durable, UV resistant housing,
resistantto rocks and water
• IP66, IP67 and IP69K rated
• Meets AS2809:2020 standard
BMIS4PPV2KIT - With positive-positive
isolation for heavy vehicles with dual start
cables to isolate both battery circuits.
BMIS4PNV2KIT - With positive-negative
isolation to isolate both battery circuits.
Roll Over Sensor
The REDARC Roll Over Sensor (ROS) triggers a battery
isolation in the event of a vehicle rollover by signalling
the isolation switch to disconnect power to the trucks
electrical system. It has been designed for high reliability,
and has undergone thorough testing.
Features:
• Resilient to truck electrical environments
• Improved high accuracy, reliability and
ability to detect fault conditions using dual
accelerometers designed for automotive
safety applications
• Immune to vibration, bumps, shock,
turning and electricaltransients
• IP66, IP67 and IP69K rated
ROS1224 - Suitable for
12 or 24 volt systems.
Accessories
BMIS-CK - Connector Kit for installation
on heavy vehicles where a factory
harness is not available.
BMIS-AP - Adaptor Plate designed to
retrofit the BMIS to existing installations
of other brand switches.
When used together, REDARC’s
ROS and BMIS will provide
enhanced vehicle safety.
redarc.com.au/heavyvehicle
6798-200902