Rectorseal EZT113 Installation Manual

0 2 1 4

4 9 8 3 1 1 3 0

Model No.

U.S. Patent Numbers 5,069,042 5,522,229

3/4” Standard

®

83113

(EZT113)

Yellow Cleaning Label (1)

(EZT113)

Kit Contents

3/4″ Standard Trap (1)

3/4″ Cross (1)

3/4″ Tee (1)

Red Caps (3)

Scan for more info

Condensate Trap.
No Brush

1” DROP

2 Year

LIMITED WARRANTY. RectorSeal® warrants to the original consumer purchaser (“Purchaser”)
of its product, EZ Trap
from the date of the original consumer purchase this product shall prove to be defective, it shall be repaired or replaced at
RectorSeal’s option. Your original receipt of purchase is required to determine warranty eligibility.

RectorSeal® 2601 Spenwick Drive - Houston, TX 77055
ph: 713.263.8001 - 800.231.3345 fax: [phone]
www.rectorseal.com - Like Us on Facebook

961675

®

, that it is free from defects in material or workmanship. If within two years (24 months)

instructions

®

Important:

as well as all applicable local

plumbing, drainage and

Install in strict accordance

with RectorSeal

electrical codes.

E

5° angle

Not included

C

Installation Instructions

Model No.

D

B

A

From Drain Pan Outlet ►

Trap Assembly Instructions

1. Dry t, and mark components. Rrotate U-Bend (B)

and Outlet Tee (C) to required angles for installation.

2. Glue components (A thru C) using dry t markings.

Glue assembly into Drain Pan Line.

3. Glue Drain Line (E) into center leg of Outlet Tee (C).

Drain Line must exit building with at least a 5°angle.

4. Check that Red Caps (D) are tightly secured.

5. Attach cleaning label as indicated.

Note: Insulation is required when trap is installed in unconditioned space where sweating can occur.

83113

(EZT113)