Rectorseal ACTABS User Manual

8/27/2014 ACTABS(TM) Product Datasheet

ACTABS™

Air Conditioning Drain Pan Treatments

DESCRIPTION:

Unique automatic metering dispenser

Prevents costly water overflow

damage

EPA-Registered

Eliminates the bacteria-caused

bad odors

APPLICATIONS:

Code Size

Qty. Per

Case

Lbs. per

Case

Cu. Ft Per

Case

Actabs™ with its EPA registered biocide eliminates or prevents most blockages in air conditioning and refrigeration drain lines due to the build up of bacterial slime, rust, scale, sludge, air-borne dust, silt and other solids. Actabs™ unique
dispenser when placed in drain pans will prevent water overflow in units for up to 3 months. Helps stop damage to floors, ceilings and equipment. Can be used in computer rooms.

CHARACTERISTICS:

Actabs™ EE is for systems 1 to 5 tons. Actabs™ is a larger version for systems 6 to 15 tons. It is designed for commercial size air conditioning units that are commonly found in motels, hotels, hospitals, nursing homes, schools, apartment and
office buildings. Actabs™ XX is the largest of the self metering dispensers. It was designed for larger drain pans (16 tons and over) with a greater volume of condensate water flow. Actabs™ JR. tablets are packed in bulk for economic monthly
treatments for all systems.

When used according to directions, it will inhibit the growth of the following organisms: thermoactinomyces vulgaris, pseudomonas effusa, pseudomonas aeruginosa, bacillus circulans, bacillus circulans, bacillus licheniformis, bacillus megaterium
and aerobacter aerogenes.

PACKAGING:

1/3

8/27/2014 ACTABS(

Actabs™ EE

68102 3 tablet pou ch 50 3 0.31

Actabs™

68108 6 tablet pou ch 72 8 0.46

INS TRUCTIONS:

Flash Point SETA CC None
Color
Shelf Life 2 years

RectorSeal® makes the Limited Exp ress Warrant y that when the instruc tions for storage and hand ling of our produ cts are followed we warrant our prod ucts to be free from defects. THIS LIM ITED EXPRESS WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER EXPRESS

TM) Product Datasheet

Actabs™ JR

68104 200 ta blet bot tle

12

13

0.45

It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Remove inner package containing tablets from outer plastic bag. Place the package, holes down and tablets facing up, into drain pan at a point as far
from the drain hole as possible. Be sure that the single tablet at one end of the package is farthest from the drain hole. In extremely dirty pans it would be helpful to clean the pan before placing the package. The dirt might block the
opening in the bottom of the package and inhibit metering of the ACTABS™. Actabs™ use one package for each 2 square feet of the drain pan area. Actabs™ EE use one package for each 1.75 square feet of drain pan area. The
pouch should not be submerged.

Actabs™ JR. for up to 10 gallons of water, start treatment by dropping 12 tablets into humidifier reservoir or drain pan of air conditioner. Apply 12 additional tablets every 3 months or whenever odors occur.

For additional technical information, call Toll Free 1-800-231-3345.

PRECAUTIONS:

FOR CHEMICAL EMERGENCY, SPILL, LEAK, FIRE, EXPOSURE OR ACCIDENT,

CALL CHEMTREC - DAY OR NIGHT 1-800-424-9300

D A N G E R!

CORROSIVE

PRECAUTIONS: Corrosive. Causes irreversible eye damage. Do not get in eyes or on clothing. Wear adequate protective gear and clothing. Wash after handling. FIRST AID: For any overexposure, get immediate medical attention after

first aid is given. Eyes - Flush 15 minutes with clean water. Skin - Wash with soap and water. Ingestion - Only if conscious, give large amounts of water. Seek immediate medical attention. STORAGE AND HANDLING: Store in a cool,
well ventilated area. Keep container upright and tightly closed. Do not expose to heat or store at temperatures above 120 degree F. Do not reuse empty container. Wrap container and put in trash collection. KEEP OUT OF REACH OF

CHILDREN.

For additional information, refer to Safety Data Sheet.

SPECIFICATIONS :

Sugge stion s an d recommendations covering the us e of our product s are based o n ou r past e xperience and laborato ry findings. However, as we have no control as to t he method s and conditions o f application, we only as su me responsibility for the uniformit y of our
products within manufacturing tolerances.

LIMITED WARRANTY:

2/3