Recoton AW2000 Users Manual

Instruction Manual: AW2000
Magnetic Technology Rear Speaker

1.Connect transmitter to the sound source, using the supplied cable.

2. Connect the male connector of the transmitter box to the TV or VCR.

3. Connect the cable line, DSS downlead, or TV antenna to the female connector on the
transmitter box.

4. Connect the power supply adaptor to the transmitter and plug it into a wall socket. The
furnished power supply operates on standard U.S. 120Volt, 60 Hz AC. For other voltage
applications, contact Recoton Customer Service at 800 RECOTON.

5. Move the power switch to the “on” position.

6. Adjust the modulation control until the modulation indicator shows the proper level. This will
result in getting the clearest sound possible.

7. Locate the receiver battery compartment cover, and remove it.

8. Install 10 fresh “C” batteries in the compartment, giving careful attention to the polarity
markings in the cabinet, and replace cover.

9. After selecting the spot that you desire the speaker to be used, mount the speaker on the wall,
or place it on a table

10. Move the receiver power switch to the “on” position

11. If an audio source is present, advance the receiver “volume” control to the desired listening
level.

In case of difficulty:

Verify that the wall socket that the transmitter power adaptor is plugged into is live. Plug a lamp
into it to test.

Verify that the receiver batteries are not discharged. Try a fresh set.

RECOTON CORP.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

User modification of this unit is a violation of FCC certification rules. There are no user
serviceable components inside. Contact Recoton customer service at 800 RECOTON.

Specifications:

Transmitter

Frequencies: 2.28 and 2.79 MHz

Output power: Maximum allowed by FCC and Industry Canada regulation.

Power Consumption: ____ W from 120V AC

Audio input: ______to_______ Volts, RMS

Receiver

Receive frequencies: 2.28 and 2.79 MHz
Audio output: ______ W RMS into Ω

Frequency response: _____ to _________

Battery Life: _____ Hrs at 1 W output (Nominal. Recoton has no control over battery
manufacturers quality and longevity.)

FCC ID: CLVAW2000
EXHIBIT #: 4