Recordex RX-100SA Quick Start Manual

Standalone DVD/CD AutoLoader Duplicator

QUICKSTART GUIDE

Recordex RX-100SA

™

Recordex® RX-100™ DVD/CD AutoLoader - QuickStart Guide

The box and foam used to package your RX­100™ is specially designed to prevent shipping damage. If your duplicator requires
service during the warranty period and you don’t have original packaging we will send
you a replacement set, but the cost for a replacement set is $45.00. So we recom­mend keeping the original box & foam.

When calling for service we will
need to know the serial number of your RX-100™, the date of purchase, and the
name of the company that sold you your AutoLoader.

Your serial number is located on the outside of your

AutoLoader box. You’ll also find the Model number listed on the same label. We rec-

ommend writing the Serial number down in the inside cover of this quick start guide.
NOTE: If your unit is not marked with a serial number then record the name of the
reseller that sold the unit, the invoice number, and the date of purchase.

If after reading the user’s manual you’re still having trouble with

your RX-100™ then give us a call or send us a message. Service Phone: 478-237-

Please duplicate responsibly and comply with all copyright rules. RecordexUSA is
not responsible for the misuse of any RecordexUSA duplication equipment.

Page 3

Verify the contents of your package against the image below.

Save the box and packaging material for return shipment should your printer
require service.

STEP 1: Unbox and Verify Contents

Figure 1.1 Package Contents

Base Unit

50-Disc
Collection Tub

100-Disc
Collection Tub

Power Cable

Disc Retrieval

Rod*

Input Tank Guide Rods

Recordex® RX-100™ DVD/CD AutoLoader - QuickStart Guide

STEP 2: Assemble AutoLoader

Figure 2.1 Insert Input Tank Guide Rods

STEP 2a: Insert the four Input Tank
Guide Rods into the holes on the top
of the base unit.

STEP 2b: Insert the 50 or 100-disc
collection tub into the slot on the left
side of the duplicator. NOTE: When
using the 100-disc tub the tub will
hang over the table edge.

Figure 3.1 Plug In AutoLoader

Plug end B into the rear of the base unit. Plug end A into a grounded 110V
electrical outlet.

1. Connect the power cord to the RX-100SA.

2. Connect the power cord to the wall outlet.

NOTE: Use only a grounded outlet. It is highly recommended that you pro­tect your autoloader from possible electrical damage by connecting it to a
surge protector or an uninterruptible power supply (UPS).

A

B

STEP 3: Connect Power to RX-100

2b

Page 5

STEP 4: Load Blank Media Into The Input Tank

To fill the input tank start by placing a single disc into the input

tank. This will give you a solid base to place the remainder of the
blank disc stack.

The input tank can hold 50 or 100 discs depending on which input

tank guide rods are installed.

Top of Disc

Load Single Disc
First. Then Load
Rest of Stack.

Load media with the
label side up and the
data side down.

Figure 4.1 Loading Blank MediaFigure 4.1 Loading Blank Media